User Manual

Page 1 of 4
006145 Rev.T Date 06-06-12 JWC
1. READ AND FOLLOW ALL DIRECTIONS.
2. NEVER stand on table or INJURY MAY OCCUR.
3. NEVER allow user to sleep unattended on table or INJURY MAY OCCUR.
4. NEVER leave an unconsc ious user unattended on table or INJURY MAY OCCUR.
5. DO NOT use table for transporting user in or with ANY type of vehicle or trailer. Winco tables have not been tested
or approved for use by an occupant in any type of vehicle or trailer.
6. NEVER leave an infant or child unattended on table or INJURY MAY OCCUR.
7. DO NOT allow children to pla y on or with the table or INJURY MAY OCCUR.
8. DO NOT put hands, feet or clothing into any openings on table. Attendant MUST confirm that users hands and feet
are safe while positioning patient or INJURY MAY RESULT.
9. Periodically, recheck tightness of all nuts, bolts and screws.
10. USE ONLY WINCO AUTHORIZED REPLACEMENT PARTS.
11. NEVER EXCEED the recommended weight capacity of 400 lbs. (181.4 kg).
12. SAVE THESE INSTRUCTIONS for future reference and training.
8400 Pediatric Table &
8450 Multi-Use Table
CUSTOMER INSTRUCTIONS
Tools needed:
 Phillips-head screwdriver
 7/16” wrench (multiple size wrench includ ed)
 Scissors or box cutter
 - If using powered tools always start hardware together by hand first -
SEE “Parts Guide” (pg.3) for visual reference during assembly.
1. After checking your product for any shipping damage, table needs to be positioned upside-down on cardbo ard
or protective surface. Remove all packing material and hardware that was secured for shipping. Cut tape on
corners of box so that cardboard will lay flat while you assemble table.
Leg Installation for 8400-8450:
2. Find the two Table Legs that you will be installing to the Table Frame Rails and the threaded holes in the
wood table bottom.
3. One at a time, position the (2) Table Legs between Table Frame Rails (as shown in parts guide), and
continue to step #4.
4. Install (2) ¼-20 x 1-½” screws through the upper brace on each of the (2) Table Legs and into the (2)
threaded holes on bottom of Upholste red Top.
NOTE: Do not fully tighten at this time.
5. Secure the Table Legs to the Table Frame Rails with (4) ¼-20 x 2-½” screws and ¼-20 nuts.
NOTE: Do not fully tighten at this time.
PLEASE READ AND FAMILIARIZE YOURSELF WITH ALL INSTRUCTIONS BEFORE PROCEEDING WITH ASSEMBLY
PLEASE READ AND FAMILIARIZE YOURSELF WITH ALL INSTRUCTIONS BEFORE USING THIS PRODUCT.
If you have trouble understanding these in structions contact your dealer or Winco customer supp ort, [phone]
before attempting to use this product; otherwise injury may occur.
8400-8450 Weight Capacity = 400 lbs. (181.4 kg.)
Winco assumes no responsibility for damage or injury caused by improper assembly,
installation, use, or maintenance of these products.