Use and Care Manual

Rotate Slightly

(Rotate the Section

Pole clockwise to

lock the whole fixture.)

Rotate Slightly

(Rotate the Section

Pole clockwise to

lock the whole fixture.)

Clip

18"

16"

Gold Ball

Plastic Collar

Top Section Pole

Plastic Collar

Section Pole

Flag

PVC Tube Parameters

Outer Diameter: 2.4inch/6.1cm

Inner Diameter: 2.27inch/5.7cm

Thickness: 0.08inch/0.2cm

Length: 19.68inch/50cm

SandConcrete

ROTATE SLIGHTLY

(Rotate the Section

Pole clockwise to

lock the whole fixture.)

Rotate Slightly

(Rotate the Section

Pole clockwise to

lock the whole fixture.)

It's recommended to dismantle the flagpole in heavy windy and severe weather conditions in case

any damage happens.

NOTE

TELESCOPING FLAGPOLE KIT

Assembly Instructions

PAGE 1
TELESCOPING FLAGPOLE KIT Assembly Instructions Gold Ball Plastic Collar Clip Top Section Pole Flag Clip Plastic Collar ROTATE Rotate Slightly SLIGHTLY (Rotate the Section Pole clockwise to lock the whole fixture.) 4th Section Pole Plastic Collar Rotate Slightly (Rotate the Section Pole clockwise to lock the whole fixture.) 3rd Section Pole Rotate Slightly (Rotate the Section Pole clockwise to lock the whole fixture.) 2nd Section Pole 1st Section Pole PVC Tube Parameters Outer Diameter: 2.4inch/6.
PAGE 2
What you will need Telescoping Flagpole Sleeve that came with the telescoping ﬂagpole 3 bags of pre-mixed concrete (40 lbs each) Level Something to mix the concrete or cement Installation Prepare a hole approximately 12”in diameter and 22” deep Place a bed of gravel or small rock in the hole Install the stop bolt and nut through the sleeve This is important since the bolt will keep the ﬂagpole up oﬀ the bottom Place the sleeve in the hole with stop bolt facing down Place gravel or small rock in and ar