User's Manual
PART
A
B
C
Tree(“A-1”)
Tree(“A-2”)
Tree(“A-3”)
1
1
1
D Tree(“A-4”) 1
E
Tree(“B-1”)
1
F
Tree(“B-2”) 1
G
Tree(“B-3”)
1
H
I
Tree(“B-4”)
Tree(“C-1”)
1
1
J
Tree(C-2”)
1
K
Tree(“D”)
1
L
Remote
2
M
Controller
1
N
O
Clip-Clasp
80
Rope(1.8m)
3
P
Rope(2.5m)
2
Q
R
S
T
U
V
Ground Stake
Audio Cable
Power
Power Cord
Cable Ties
Light String(“L1”-“L12”)
5
2
1
1
50
13(1spare)
DESCRIPTION QUANTITY
size: 21*28.5(cm)
7.5 Feet Show Tree
(White LED)
Instruction Manual
PACKAGE CONTENTS PACKAGE CONTENTS
Before beginning assembly of product, make sure all parts are present.
Compare parts with package contents list. If any part is missing or
damaged, do not attempt to assemble install or operate the product.
ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS HANG UP THE LED LIGHT
Scan & See Me!
www.ishowtree.com
Sanc QR code to
download instruction vedio
1. The first layer 3. The third layer
3. The fourth layer
2. The second layer
5. Put the finished second layer
onto the first layer
6. Put the third & fourth layer
onto the first two layers
Hang up the LED light with corresponding number on the tree top and
fix it tightly with the clip clasp
Hang up controller on the tree
a：Animation
b：Glitter
c：Waving
d：Ribbon
e：Twinkle
f：Snowing
g：Flickering
h：Combination
i：OFF
j：Music
1. Short press of on the controller to change function.
2. When press and hold the button for over 1.5s on the controller, the light
on the product will show a number(2, 4, 6, 8), which indicate the timing pattern
you would like to choose.
Release the button when you see the desire timing pattern.
Please refer to below timer pattern.
Power
Input Music
Out Speaker
REMOTE
Remote Control Instructions
1. Remove insulating tape from the battery compartment before use.
This remote is infrared and receiving distance allowance is 15 meters.
Battery Installation:
1. Unscrew battery cover off.
2. Insert a "A23" (12 volt) battery.
Note:
Timer will be disabled when power off.
Timer Function:
1): 2h tree light on / 22h tree light off(recycle every day)
2): 4h tree light on / 20h tree light off(recycle every day)
3): 6h tree light on / 18h tree light off(recycle every day)
4): 8h tree light on / 16h tree light off(recycle every day)
2. is the buttons to change the function.
a：Music Dancing
b：Auto Combination
c：Warm White Steady-on, Multi-Cascade
d：Warm White Steady-on, Multi Fade-in & Fade-out
e：Warm White Fade-in & Fade-out, Multi Steady-on
f ： Steady-on
g：Warm White Steady-on
h： Multi Steady-on
i ：Warm White Steady-on, Multi Twinkle
j ：Warm White Twinkle, Multi Steady-on
k：Warm White Steady-on, Multi Random Twinkle
l ：Fade-in & Fade-out
CONNECT CONTROLLER WITH LIGHT STRING CONNECT CONTROLLER WITH LIGHT STRING CONTROLLERASSEMBLY GROUND STAKE
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
Light string pattern
appears in wrong order
Remote control does
not function
Light string flashes
incorrectly
Light strings are assembled in
wrong order
Low battery
Insulating tape not removed
Replace new batteries
Pull out insulating tape
Replace with spare light stringLight string might be damaged
Make sure to hang light strings with
corresponding number on tree top
Use rope( ) and( )to fix tree on ground with ground stakes( )
as shown below
L1 L1
L2 L2
L3 L3
L4 L4
L5 L5
L6 L6
L7 L7
L8 L8
L9 L9
L10 L10
L11 L11
L12 L12
Power Power
Indicator
Light
Connect controller to the corresponding light string
If the remote control does not work, check battery.
Battery installation:
1. Use Phillips screwdriver to open the back cover of the remote control.
2. Replace with a new alkaline “A23G” (12 volt) battery into the compartment.
WARNING: This is not a toy and is not intended for use by children.
(A) Do not dispose of the battery in fire as the battery may leak and explode.
(B) Do not mix old and new batteries and do not mix alkaline,
standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
(C) Exhausted batteries are to be removed from the product.
(D) Do not expose the Remote Control to moisture.
(E) Dispose of battery properly by following directions on battery.
(F) Use only 12v alkaline battery type A23G of replacement, use of other battery
may damage remote.
(G) Safe for indoor use.
WARNING:
FEDERAL COMMUNICATIONS COMMISSION (FCC)
STATEMENT
FCC Caution: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. This device complies with
Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the
following measures: - Reorient or relocate the receiving antenna. - Increase the
separation between the equipment and receiver. - Connect the equipment into an
outlet on a circuit different from that to which the receiver is connected. - Consult the
dealer or an experienced radio/TV technician for help.
INDUSTRY CANADA CONFORMITY STATEMENT
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference that may cause
undesired operation of the device.
CAN ICES-005(B)/NMB-005(B)
“Power”Connect “Power”
0849490
#