Owner manual

ManualsBrandsWhite’s Electronics ManualsHeadphonesSpectra V3 SpectraSound Wireless Headphone

Your SpectraSound Wireless headphone

system has been designed from the

ground up with a single purpose -

TO WORK PERFECTLY WITH YOUR

Spectra

METAL DETECTOR!

Locate battery door- open by turning counter clockwise to

“Open” position.

Install (2) AA Batteries (provided) Take care to orient batteries

per embossed example- one up- one down.

Replace Battery door- turn clockwise to ”Lock” position.

SpectraSound™ System comes factory pre-connected

(channel 4) allowing the “Quick Connect Sequence”.

(see back page).

SpectraSound

Set Up -

SpectraSound is not an off-the-shelf system adapted for metal detection

use. A single button on the headset turns SpectraSound ON and OFF.

All other functions are a part of your Spectra Metal Detector.

Dependable - Comfortable - no-delay real-time audio that matches per-

fectly your detectors sweep speed and speaker response.

Part Number 802-5282

FCC# R8KUGWM1USHN33A.

™

Summary of content (4 pages)

PAGE 1
SpectraSound ™ Your SpectraSound Wireless headphone system has been designed from the ground up with a single purpose TO WORK PERFECTLY WITH YOUR Spectra® METAL DETECTOR! SpectraSound is not an off-the-shelf system adapted for metal detection use. A single button on the headset turns SpectraSound ON and OFF. All other functions are a part of your Spectra Metal Detector. Dependable - Comfortable - no-delay real-time audio that matches perfectly your detectors sweep speed and speaker response.
PAGE 2
More on SpectraSound™ When selecting a channel other than Channel 4, an ENABLE/CONNECT sequence is required Select Wireless Headphones and press ENTER. 1. Press ENTER to Enable “X” in box” (turn on) Wireless Headphone transmitter. 2. Press Wireless Headphone Power Button to turn ON Wireless Headphone. 3. If there is significant wireless channel interference, the built in speaker will occasionally sound. A different Wireless channel should be considered.
PAGE 3
right) a power level strong enough to provide quality sound. In-field operation at power levels less than 5 are not recommended. Channel Power Level 7. When Monitor Battery Speaker is selected “X” interference in wire less data for any reason will cause the built in speaker to sound. When Monitor Battery Speaker is not selected “empty box”, built in speaker will never sound. Plug-in headphones and wireless head phones (enabled) continue to operate normally.
PAGE 4
Quick Connect Sequence Quick Connect Wireless Headphone - Quick Connect • Select Audio or Zoom Audio • to • Press Audio Zoomed Wireless Headphone. Press to enable x • Press headphone power button. • Headphone is connected within five seconds when you hear... . • Trigger to search. Headphones automatically turn off with the detector. To manually turn OFF headphones, press headphone power button. You will hear The metal detector speaker will connect within ten seconds.