USER UNDERMOUNT RANGEHOODS M A N U A L LABEL HERE IMPORTANT: Please ensure that you read through this user manual prior to installation and use. This manual contains important information to ensure optimal performance and keep you safe. Please retain your proof of purchase, as this will be required in the event that you require warranty service. Remember to retain this manual for future reference.
CONTENTS WARNING & SAFETY INFORMATION 3 OPERATING INSTRUCTIONS 4 MAINTENANCE & TROUBLESHOOTING 5 INSTALLATION & DUCTING 6 CONTACT DETAILS Cover 2
WARNING & SAFETY INFORMATION TECHNICAL GUIDANCE DO’S & DONT’S • There shall be adequate ventilation of the room when the rangehood is used at the same time as appliances burning gas or other fuels. • Do not flambe under the rangehood. • Do not remove or inspect the filters whilst the hood is in operation. • There is a fire risk if cleaning is not carried out in accordance with the instructions. • You must read the details concerning the method and frequency of cleaning.
OPERATING INSTRUCTIONS 520, 750 & 900 UNDERMOUNT RANGEHOODS CONTROL PANEL FAN SPEED LOW/OFF/HIGH switch - Located on the letf hand side of the control panel. This unit features 3 speed settings; single line indicates low speed, double lines indicate the medium speed & triple lines indicate high speed. To turn the unit off, set the speed switch to the 0 position (off). LIGHT On/Off switch - Located on the left hand side of the control panel as indicated in the diagram above.
MAINTENANCE & TROUBLESHOOTING GENERAL MAINTENANCE Ensure that the power to the unit is switched off prior to cleaning the unit. The surface should only be cleaned with warm soapy water and a soft non-abrasive cloth. In coastal environments and humid areas more frequent cleaning is required to maintain the finish. FILTER This unit is supplied with a Aluminium filter designed for ducted installations. The Aluminium filter is dishwasher safe or can be cleaned with hot soapy water.
INSTALLATION & DUCTING IMPORTANT: Before handling the rangehood during the installation, it is recommended that you remove the filter to prevent damage. The image to the left, illustrates the minimum height from the hob surface to the underside of the rangehood. Electric hob - 600mm Gas hob - 650mm. NOTICE: IF THE INSTRUCTIONS FOR THE GAS HOB SPECIFY THE GREATER DISTANCE, THIS HAS TO BE OBSERVED. ANY INSTALLATION ABOVE 750MM WILL COMPROMISE PERFORMANCE.
INSTALLATION & DUCTING DUCTED OPTION NOTICE: ALL DUCTING MATERIAL MUST BE COMPLIANT WITH THE LOCAL LAWS IN FORCE. INSTALLATION 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. Remove the filter and light globes. (If installed) Remove the stainless steel fascia (2 screws) - take care not to damage the fascia. Determine the most effecient path for the ductwork, minimise bends and keep the length of the ductwork to a minimum. It is important to run and finish (install roof / wall caps) prior to installation on the hood.
Version 1.2 We are committed to ongoing research and development. Every effort has been made to ensure all information in the user manual is correct at time of going to print. Dimensions should be used as a reference only and actual dimensions should be taken from the physical product.