30" EYE-LEVEL&ROWAVE RANGE 30" EYE-LEVELRANGE ve Ovens, Compactors, Room Air Conditioners, Dehumidifiers, Automatic Washers, Clothes Dryers, Freezers, Refrigerator-Freezers, Ice Makers,Dishwasl
PRECAUTIONS TO AVOID POSSIBLE EXPOSURE TO EXCESSIVE MICROWAVE ENERGY II Before you begin Do not attempt to operate this oven with the door open since open-door operation can result in harmful exposure to microwave energy. It is important not to defeat or tamper with the safety interlocks. Read these instructions completely and carefully. If followed, they will simplify the installation job. If your range does not have a microwave upper oven, disregard the following microwave information.
C. Electrical requirements Wire size and connectors must conform to the ampere rating of the range as stated in paragraph C-l. IMPORTANT: Attach special ring connectors to the aluminum house wiring that are UL listed and designed for joining copper to aluminum. These special ring connectors (available at electrical supply houses) can be attached directly to the range terminal block.
Begin the installation Begin electrical connection Remove racks and all other contents from oven before moving appliance. Be sure to remove all packaging material (cardboard, protective film, etc.) from range before use. A.
B. Strain relief required LOCKING , Use this wiring method ONLY if local codes permit connecting frame grounding conductor to neutral wire of power cord. THIS APPLIANCE IS MANUFACTURED WITH NEUTRAL TERMINAL CONNECTED TO THE FRAME. If local codes do not permit grounding through the neutral. The 3-conductor cord or cable assembly must be replaced by a 4-conductor cord. The replacement cord must be rated 240 volts, 50 amperes and investigated for use with ranges. II 1. Connect terminal.
/A 1 Level and position ” the range Gl NOTE: If installing the option vent hood, go to that step now. Instructions are on page 7. Level and position the range after the vent hood is attached. ‘- I SPIRIT LEVEL -\ 5 Check operation CAUTION: Do not touch any heating and you may be burned. elements. They may be hot A. Surface elements Turn on each of the 4 surface elements. Check tain they heat and check for proper operation indicator light(s). to be cerof surface B.
Ll Installing optional vent hood C. Connect vent hood CAUTION: Disconnect vent hood. from electrical supply before installing A. Spacerequired EYE-LEVEL RANGE Reach through hole in bottom cord until all slack is removed. Install vent nection. hood BEFORE making When measuring, remember justed. Total height needed final that leveling for vent hood electrical con- legs will be adis 71-7/e” with of vent hood, pull out power Place vent hood on the top of the oven.
HOME 5% APPLIANCES Making your world a little easier. In the event your WHIRLPOOL appliance should need service, call the dealer from whom you purchased the service company. He is in the Yellow Pages of your telephone appliance or a WHIRLPOOL franchised TECH-CARE@ directory listed under “Appliances-Household-Major-Service and Repair.” You can also obtain his name and number by dialing, free. the Whirlpool COOL-LINE” service (SW) 2551301. Dial just as ou normally dial long distance.