Model: HFCX80410 www.whirlpool.com.
EN Quick guide THANK YOU FOR BUYING A WHIRLPOOL PRODUCT. In order to receive a more complete assistance, please register your product on www.whirlpool.com.sg Before using the appliance carefully read the Safety Instructions.
PROGRAMS The duration of these programs will depend on the size of the load, types of textiles, the spin speed used in your washer and any extra options selected. In machines equipped with display, the duration of the cycles is shown on the control panel. The remaining time is constantly checked and adjusted during the drying cycle to show the best possible estimate.
EN Quick guide CARE AND MAINTENANCE WARNING: unplug the dryer during the cleaning and maintenance procedures. Emptying the water tank after each cycle (see Fig. A). Pull the container out of the dryer and empty it into a sink or other suitable drain, then place it back properly. Do not use the dryer without having inserted the container back in place. Cleaning the door filter after each cycle (see Fig. B).
TROUBLESHOOTING EN Before contacting the After-sales Service, refer to the table below. Often the malfunctions are minor and can be solved in few minutes. Malfunction Possible cause The plug is not inserted into the socket. The tumble dryer does not turn on. The plug is faulty. A power failure occurred. The door has not been closed properly. The tumble dryer does not start. Garments are wet at cycle completion. The drying times are very long. A time delay was set to the start of the cycle.
1 4 2a 5a 1 2 10 mm 2b 5b 15 mm 15 mm 3 max 70 cm 28 inch max 2 cm max 0.79 inch 6 ..............
SAFETY INSTRUCTIONS IMPORTANT TO BE READ AND OBSERVED This symbol reminds you to read this instruction manual. Before using the appliance, read these safety instructions. Keep them nearby for future reference. These instructions and the appliance itself provide important safety warnings, to be observed at all times. The manufacturer declines any liability for failure to observe these safety instructions, for inappropriate use of the appliance or incorrect setting of controls.
EN for the correct assembly are supplied with the stacking kit. ELECTRICAL WARNINGS It must be possible to disconnect the appliance from the power supply by unplugging it if plug is accessible, or by a multi-pole switch installed upstream of the socket in accordance with the wiring rules and the appliance must be earthed in conformity with national electrical safety standards. Do not use extension leads, multiple sockets or adapters.