3Lirlpool AUTOMATICICE CUBE MAKER User’s Instructions & Care and Cleaning Guide MODEL - CHS12RC CHSl2RS CHE-12RC CHE-12RS
General Information The machine produces clear hard ice by circulating water over a freezing plate. As the water freezes into ice, minerals in the water are constantly being rejected and a clear sheet of ice is formed. When the desired thickness is reached, the ice sheets are released and slide ontc a cutter grid where the sheet is divided into individual cubes, At the end of each freezing cycle the water containing the rejected minerals is discharged to the drain.
Circulate for “off” position 7. five minutes, Then set service to syphon out the water. switch Set service switch to “clean” position. Slowly pour the cleaning solution into the water reservoir pan. If the solution foams, stop pouring until the foam subsides and then pour the rest of the solution. 8. Allow the solution to circulate until freezing plate surface has dissolved. the scale on the 9. When the plates are clean, place the service switch the “off” position.
hose connected to the bottom of the pan. The plastic pan should then be moved to the left until the right edge can be dropped off the mounting flange. During removal the pan may have to be flexed slightly. 14. Remove the ice cube deflectors between each cutter grid. The lower left edge has a locking tab which must clear the grid frame. Push left and up on the lower edge of the deflector. The right edge then readily comes off the lower flange of the cutter grid above.
Water Cooled Models Over a prolonged period of time scale will form on the inside walls of the water condenser which must be removed. When scale forms the ice maker becomes less efficient and requires larger amounts of water for cooling. The scale is cleaned from the inside of the condenser walls with chemicals, It is recommended that the scale removal should be performed by your WHIRLPOOL ice maker dealer. Turn Clockwise To Increase Thickness Air Cooled IN. THICKNESS 3/8” MAX.
Check the following A. before calling a service Unit does not run: 1. Make sure service switch on” or “timed on”. 2. 3. man: is posltioned If service switch is in “timed on” control timer must be in the timed allows the machine to operate. Check fuses in power and remote refrigeration supply unit. to “normal position then setting which to ice maker C. Unit I, runs but produces no ice: D. Check all mercury switches positioned over water trough. Arms must be vertical.
