Instructions / Assembly

5. Unscrew the coinslide retaining bolt with

a 5/16” socket by turning counter clock

wise and remove the bolt.

6. Push the coinslide up, and then pull it

forward to remove from the metercase.

7. Set the coinslide and extension assembly

on a level surface and remove the return

spring(s) from the spring bracket.

8. Place coins in the coinslide of the proper

vend amount (factory preset on coin

equipped models is $1.00) and push the

slide all the way in until the coins drop

through the coinslide.

COINSLIDE PRICE VEND CHANGE INSTRUCTIONS

1. Unplug unit or disconnect power.

2. Unlock the metercase access panel or

collar control panel lock and remove the

control panel from the collar assembly.

3. On single washer and dryer models, lift

the metercase access panel up at the

back and remove.

4. On mechanical stack dryer models open

the console by lifting it up off the bottom

mounting flange. On electronic stack

dryers slide the control panel to the left,

then carefully open the control panel by

swinging the right side away from the

collar.

Electrical Shock Hazard

Disconnect power before servicing.

Replace all panels before operating.

Failure to do so can result in death or

electrical shock.

The following procedure will guide the user

through changing the coinslide vend amount

for a factory equipped or ESD vertical 8

coinslide. The procedure will be similar for

other coinslide manufacturers, consult the

manufacturers installation instructions. If the

coinslide(s) are installed, they must be

removed prior to changing the vend price. If

the coinslide(s) have not yet been installed,

skip to step 6.

PAGE 1
COINSLIDE PRICE VEND CHANGE INSTRUCTIONS 5. Unscrew the coinslide retaining bolt with a 5/16” socket by turning counter clock wise and remove the bolt. The following procedure will guide the user through changing the coinslide vend amount for a factory equipped or ESD vertical 8 coinslide. The procedure will be similar for other coinslide manufacturers, consult the manufacturers installation instructions. If the coinslide(s) are installed, they must be removed prior to changing the vend price.
PAGE 2
9. With the slide still all the way inserted, remove the spring bracket screw and spring bracket. 12. To increase the vend price, remove blank inserts and install the metal functional inserts. 10.Remove the coin inserts (2 blanks, 2 functional) from the coinslide are shown. To decrease the vend price, remove functional inserts and replace with blank inserts. 13. Reinstall the three insert retaining plate screws. Turn the coinslide over and place unused inserts (up to 4) in the slide storage.
PAGE 3
16. While holding the slide in, insert the coinslide into the metercase, making sure the extension clears the coin funnel. (Fig. 1) 17. Pull down slightly to lock the coinslide into place. (Fig. 2) Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use adaptor. Do not use an extension cord. Failure to follow these instructions can result in death, fire or electrical shock. Fig. 1 Fig. 2 18.