Instruction for Use

EN -1-
Chart
RINSE AID INDICATOR
When lit (at the end of the cycle),
the rinse aid dispenser needs to be
refilled.
400010791716
SALT INDICATOR
When lit (at the end of the cycle),
the salt reservoir needs to be
refilled.
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY BUTTON EXCEPT CANCEL/OFF BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.
WASH TIME DISPLAY
Indicated the cycle duration and the remaining time (h:min). With “Delayed start” selected it
indicates the time remaining until program start (h.00) - below 1h (0:min).
If “Fx Ey” messages appears on the display, see page 9 - chapter “What to do if...”.
START/RESUME
BUTTON
Push this button to start the
selected program: the
indicator lights up and goes
off at the end of the
program.
When the door is opened
during a washing cycle, the
cycle is temporarily paused:
the Start indicator blinks.
To resume the cycle push
Start button and close the
door within 3 seconds.
CANCEL/OFF
BUTTON
Push this button to switch off
the control panel.
If pressed when a program
is running it cancels the
program ongoing draining
water for 1 minute (0:01 is
shown into the display).
If pressed when the
dishwasher is switched
off, it drains any possible
liquids from dishwasher
(1 minute process).
DELAYED START
BUTTON
Push the button
(repeatedly) to delay the
start of the program -
delay indicator turns on.
Adjustable from 1 to
24 hours. With each press
of the button, the delay
increases by one hour and
after “h 24” returns to
“h 00”.
When this option is
selected the delay
indicator turns on.
Then press the START
button.
The dishwasher will start
after the set time.
TABLET SETTING
This setting allows to
optimize the cycle
performances according
the type of detergent
used.
Push the Tablet button
for 3 seconds (until the
indicator lights up) if you
are using the combined
detergents in tablet (rinse
aid, salt and deteregent in
1 dose).
If you are using powder
detergent or liquid
detergent, the Tablet
indicator on the control
panel has to be off.
PROGRAM
SELECTION
BUTTON
Push “P” button
(repeatedly) until
selected program
number is shown on
the display (P1...Px) -
see “Table of
programs” next page.
ANTIBACTERIAL
RINSE
This function activates an
antibacterial rinse at the end
of the wash cycle,
guaranteeing a further
reduction of bacteria. Press
the button to activate or
deactivate the function.
This function can be used
with the programs indicated
in the table of programs.
The dishwasher door must
be kept shut for the entire
duration of the program in
order to guarantee reduction
of bacteria.
If the door is opened the
indicator lamp starts flashing.
1/2 LOAD BUTTON
Half load cycle can be
used for the upper or
lower rack.
Select the required
program then press the
“Half Load” button - the
light comes on.
Turns off at the end of the
program.
The “Half Load” option
can be used with the
programs indicated in the
table of programs.
Reference guide

Summary of content (12 pages)