Self-Cleaning Hot & Cold Hidden Bottled Water Cooler With Display Model No.: 8LIECH-SCDSSFWL USERS’ MANUAL The appearance of your product may differ from the above illustration. SAVE THIS MANUAL FOR FUTURE USE For service, call: 1-855-594-4755 or E-mail Whirlpool@electrotemp.
Model # 8LIECH-SCDSSFWL: Page 2 TABLE OF CONTENTS Safety Precautions-Electrical Requirements .......................................... Safety Precautions .......................................................................................... Product Features ............................................................................................ Key Information for Future Use .................................................................... Specifications ........................................
Model # 8LIECH-SCDSSFWL: Page 3 SAFETY PRECAUTIONS Your safety and the safety of others are very important. We have provided many important safety messages in this manual and your appliance. Always read and follow all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or injure you and others.
Model # 8LIECH-SCDSSFWL: Page 4 PRODUCT FEATURES Congratulations! You have chosen a technology advanced, state-of-the-art water cooler. To provide consistently cold water, this water cooler forms an "Ice Bank" in the cold tank. Formation of the initial "Ice Bank" can take up to 1 hour. WHEN THE UNIT IS PLUGGED IN FOR THE FIRST TIME, IT CAN TAKE OVER AN HOUR BEFORE THE "ICE BANK " FORMS AND THE UNIT CAN PROVIDE THE COLDEST WATER.
Model # 8LIECH-SCDSSFWL: Page 5 SPECIFICATIONS Energy Verified Version 2.0 AC 120V / 60Hz / 6.5Amp R-134A ＜100 Watts 6 Litres / 1.59 Gallon Factory set at 7°C/45°F/ Adjustable via display from 4°C/39°F to 13°C/55°F 650 Watts 6 Litres / 1.59 Gallon Factory set at 85°C/185°F temperature adjustable via display from 71°C/160°F to 93°C/199°F temperature will remain constant 102.8cm H x 32.0cm W x 38.2cm D 40.5inch H x 12.6inch W x 15.0inch D 16.2 Kg / 35.
Model # 8LIECH-SCDSSFWL: Page 6 UNPACKING AND ASSEMBLY Remove the dispenser from packaging: WARNING TOP TO OPEN: TOP Excessive Weight Hazard TOP TOP Use two or more people to move and install the water cooler and the bottles. Failure to do so can result in back or other injury. 1. Lay the box containing the unit on its side. 2. Open bottom flaps of the cardboard box. 3. Stand cooler upright, with box flaps unfolded. 4. Pull box straight up. 5. Unpack the drip tray and insert it into the dispenser.
Model # 8LIECH-SCDSSFWL: Page 7 CLEANING PRIOR TO INITIAL USE To remove any odors or dust that may have accumulated during shipment, you may want to clean the dispenser prior to first use. Time Required: 45 minutes. Note: Do NOT plug in power cord yet. 1. Move the dispenser away from the wall and turn it 90° in either direction. 2. Turn the power switches to OFF. A 3. Remove the water bottle and the probe from the water bottle. 4. Place a 2 gallon or larger bucket under the probe assembly. 5.
Model # 8LIECH-SCDSSFWL: Page 8 OPERATION IMPORTANT The unit’s self-cleaning feature prevents formation of Biofilm. The self-cleaning feature is not intended for water purification. This unit is intended for use with high-quality bacteriologically safe bottled water only. Do NOT use other liquids. Do NOT use for other purposes. Warranty is void if unit is used with any other liquids, including tap water, coffee, tea, juices, beer, or wine.
Model # 8LIECH-SCDSSFWL: Page 9 Note: When using a 5 gallon rectangular bottle, slide it into place as shown in the illustration below. • If the probe tube A and B are not sealed (see previous page), the pump will run a few minutes and the night lights will flash. To correct, open the door, re-attach the probe, and close the door. • If the lights continue to flash, your bottle may be empty or there may be an issue with the water tube lines. Call 1-855-594-4755 for assistance. 3.
Model # 8LIECH-SCDSSFWL: Page 10 • The circular shapes in the drip plate help to align the flow of water. This unit dispenses water quickly. To avoid splashes, hold the cup as close to the tap as possible. 2. Press the right control downward to start dispensing water. 3. Release the control once desired fill level is achieved. Dispensing Hot Water Note: After setup, hot water will be available in 15-20 minutes. The Energy Saver Feature keeps hot water on standby at 80°C/176°F.
Model # 8LIECH-SCDSSFWL: Page 11 DISPLAY’S OPERATION EXPLANATION Cold and Hot water symbols will flash when heating and cooling are working. The unit’s display shows the current temperature of the chilled and heated water. It also allows for temperature customization of both cold and hot water. Adjusting temperature: - Hold SET button until hot temperature display starts flashing. - Touch to adjust temperature incrementally. - Touch SET to save - Do the same for cold-water temperature.
Model # 8LIECH-SCDSSFWL: Page 12 PROPER CARE & DESCALING General Cleaning Perform: As needed Time Required: 5 minutes. Note: Do NOT use abrasive materials or chemical cleaners. 1. Clean cabinet surfaces with a soft cloth and warm soapy water. 2. Wipe dust from back of dispenser to improve the unit’s efficiency. 3. Remove the drip tray assembly by sliding it forward. Remove the cover. Wash both tray and cover in a dishwasher or wipe parts clean with a soft cloth and warm soapy water. 4.
Model # 8LIECH-SCDSSFWL: Page 13 2. Attach or insert the probe to the bucket/bottle. 3. Place the bucket/bottle into the cooler and close the door. The water will be pumped up into the holding tanks. 4. Plug in the cooler and turn on the hot switch located at the back of the cooler. Do not turn on the cold-water switch. 5. Wait for 1 hour. 6. Unplug the cooler from the wall 7. Using rear drain plug, drain the water from the cooler into a bucket and discard the water. A.
Model # 8LIECH-SCDSSFWL: Page 14 TROUBLESHOOTING Call 1-855-594-4755 for service. Problem: Stainless steel surfaces are smudgy or fingerprinted. Solution: Use paper towel to wipe excess oils until surface feels dry to the touch. • To maintain beauty of stainless steel, oil it periodically using a stainless steel cleaning solution available at hardware stores, or use mineral oil (unscented baby oil). Problem: The buttons for dispensing water are slow-moving or jammed.
Model # 8LIECH-SCDSSFWL: Page 15 Problem: Buttons are stuck. Solution: Apply mineral oil (unscented baby oil) to the button slides to reduce friction. Problem: No water is coming from the taps. Solution: Make sure the water bottle is not empty. If it is, replace it. If not, adjust the probe to an appropriate length. • Make sure that you fully press the water controls. • Make sure that the probe connection with the water bottle forms a complete seal. • Make sure that the door is closed.
Model # 8LIECH-SCDSSFWL: Page 16 LIMITED WARRANTY Electrotemp Technologies Inc., (“Vendor”) warrants to the original purchaser of this dispenser, and to no other person, that if this dispenser is assembled and operated in accordance with the printed instructions accompanying it, then for a period of one (1) year from the date of purchase, all parts in such dispenser shall be free from defects in material and workmanship.
名称：说明书8LIECH-SCDSSFWL(加拿大沃尔玛）-English 图号：5M009863X115(E+F) 修订表 修订 A 修改内容 修改人 日期 李雪玲 2013－08-30 B 1.再次按客户和老板要求修改 2. 大部分页面都有修改 3. 删掉16 17 18页 李雪玲 2013－09-11 03 1.再次按客户要求修改第2页，5页，第12页，17页 2.超重警告标贴和电气警告标贴字体和大小有调整 3.增加不锈钢清洗 李雪玲 2013－10-11 04 第5页 部件图4 由cold water更改为hot water， 部件图5 由hot water更改为cold water 李雪玲 2013－11-01 李雪玲 2014-04-10 1. 第1页，5页，6页，8页，9页，10页，18页饮水导杆变回原来不加套 2. 第2页增 加电子温控说明 3. 惠而浦要求修改他们的地址 4. Electrotemp 服务电话由888-828-1426变更为1-844-926-6537 5.
修订表 修订 13 修改内容 修改人 1 P5 删除 specifications下面那段内容,删除non-adjustable 2 调整note 字体 3 p6 installation 第一段 in a cold shade改为cool and shady; 4.P8中 IMPORTANT INITIAL SET UP 字体大小更改； 5.p11 -12 改为PROPER CARE & DESCALING, 后面的 内容改为从general cleaning to taset or smell; p12 增加 Water cooler is quiet while on standby mode: 这段内容；sanitizing 这段内容更改；Step A改为 how to drain water 6. 删除p13，14，18 7.p17中删除 water tastes bad整段；Dispenser is noisy 增加内容 use materovided .... 8 目录相应页码更改。大变更 第12页，第13页清洗热胆部分更新 14 15 铝线压缩机，净重由16.4 kg / 36.
