ADP8000
For detailed operating method read the corresponding content on the instruction manual. Switch on the appliance Fill the detergent dispenser Press the Power button to switch on the appliance. Open the door. Compartment With each wash cycle. Compartment With pre-wash only. (Refer to the “Fill the Detergent and Rinse Aid dispensers” section.) Check the rinse aid level Load the baskets Select a program Electric indicator on control panel.
Dear Customer, Please carefully read this manual bef ore using the dishwasher, it will help you to use and maintain the dishwasher properly. Keep it to refer to it at a later date. Pass it on to any subsequent owner of the appliance. This manual contains sections on Safety Instructions, Operating Instructions, Installation Instructions and Troubleshooting Tips, etc. Control Panel....... .... ........... .... ........ ... .... ........ ..2 Dishwasher Features........ ................. ........... . ..
When using your dishwasher, follow the precautions listed below: Under certain conditions, Hydrogen gas may be produced in a hot-water system that has not been used for two weeks or more. HYDROGEN GAS IS EXPLOSIVE. If the hot-water system has not been used for such a period of time, before using the dishwasher turn on all the hot-water taps and let the water flow from each of them for several minutes. This will release any accumulated hydrogen gas.
To get the best performance from your dishwasher,read all operating instructions before using it for the first time. 1 2 3 4 8 Powe r in dica tor light: Indicates th e p owe r supply. 5 8 6 7 D ispl ay widow indicat es as follows : 2 Power button: To turn on/off the power su ppl y. 3 A ll-in-1 fu nction button: To select All-in -1 function. 4 Half load function Button: To select Half load function. All-in-1 function indi cator: 5 Program button: To select your desired program.
Rinse Aid Dispenser The rinse aid is released du ring the final rinse to prevent water from forming droplets on your dishes, which can leave spots and strea ks. It also improve s drying by allow ing water to roll off the d ishes. Your dishwa sher is designed to use liquid rinse aids. The rinse aid dispenser is located inside the door next to the detergent dispenser. To fill the dispenser, open the cap and pour the rinse aid into the dispenser until the level indicator turn s co mpletely black.
Adjusting Rinse Aid Dispenser The rinse aid dispenser has four scales. Set the lever to the position "3". If there is excessive foaming at the end of the wash, reduce the setting to "1" or "2". If dishes are wet or streaky after drying, adjust to "4". NOTE: Increase the dose if there are drops of water or lime spots on the dishes after washing. Reduce i t if there are sticky whitish stains on your dishes or a bluish film on glassware or knife blades.
Amount of Detergent to Use I f the lid i s closed: press release button. The lid will spring open. Always a dd the d etergent just before start ing each wash cycle. Only use branded det ergent aid for dishwasher. D ishwash er detergent is corrosive! Take care to keep it out of reach of children. Proper Use of Detergent Use o nly detergent specifically made for the use in dishwashers. Keep your d etergent fresh and dry. Don't put powdere d detergent into the dispenser until you're ready to wash dishes.
Use of All-in-1 Tablet Detergents These products are detergents with integrated and com bined detergent/ rinse aid and sal t functions. B efore using these products you should first check that t he water hardness in your su pply is co mp atibl e wi th the use of these products as per th e de terg ent manufacture r information on the prod uct packing. These produ cts should be strictly use d according to the detergent manufa cturer's instructions.
Consider buying utensils wh ich are ident ified as dishwasher-proof. Use a m ild detergen t that is describe d as 'kind to dish es'. If necessary, seek further informa tion from the detergent manufacturer. To prev ent damage, take glass and cutlery ou t of the dishwasher a s so on as possible after the program has ended.
The u pper basket is designed to hold more delicate and lighter dishw are such as glas ses, coffee and tea cups and saucers, as well as plates, small bowls and shallow pans (as long as they are not too dirty). Posit ion the dishes and cookware so that they w ill not get moved by the spray of water. Cups 1 2 3 Saucers Glasses The upper rack i s for delicate a nd lighter dishware such as glasse s, coffee & tea cups, sau cers, plat es, bowls, and shal low pans (provi ded t hese are not too dir ty).
We suggest that you place large items and the most difficult to clean items are to be placed into the lower basket: such as pots, pans, lids, serving dishes and bowls, as shown in the figure below. It is preferable to place serving dishes and lids on the side of the racks in order to avoid blocking the rotation of the top spray arm. Plea se b e reminded t hat: Pots, serving bowls, etc, must always be placed top down. Deep pots should be slanted to allow water to flow out.
Intensive Heavy Pre-wash(50℃) Pre-wash Wash (65 ℃) Rinse Rinse Rinse (55 ℃) Drying 5/25g Required 130 1.5 23 Pre-wash(50℃ ) Wash (50 ℃) For heavily soiled loads, such as pot s, plates, glasses Rinse Rinse (65 ℃ ) and heavily soi led pans. Drying 5/25g Required 155 1.3 15.5 For the heaviest soil ed loads, such as pots, pans, casserol e dishes and dishes that have baked on food. For normally soiled loads, such as plates, glasses, bowls and normally soiled pans.
Starting a cycle wash 1 Open the door, draw out the lower and upper basket, load the dishes and push them back. It is recommended to load the lower basket first, then the upper one (see the section entitled “Loading the Dishwasher” ). 2 Pour in the detergent (see the section entitled“Detergent and Rinse Aid” ). 3 Ensure that the dis hwasher is connected to the p owe r supply, th e water is connected an d turned on and the drain hose is connected correctly.
Unloading the dishwasher It is normal that the dishwasher is wet inside. Empty the lower ba sket first and the n the upper one. This will avoid water dripping from the upper basket onto the dis hes in the lower one. The filter prevents larger remnants of food or other objects from getting inside the pump. The residues may block the filter, in this case they must be removed. The filter system consists of a coarse filter, a flat (Main filter) And a microfilter(Fine filter).
The entire filter assembly should be cleaned at least once a week. Cleaning the Filter To cle an the f ilters, use a cleaning brush. R eassemble the filter parts as shown and re-insert t he entire assembly in the dish was her, position ing it in its seat and turn i t in clockwise direction. W hen cleaning the filters, do not knock on them. Otherw ise, the filters could be contorted and the performance of the dishw asher could be decreased.
After Every Wash When not in Use for a LongTime After every wash, turn off the water supply to the appliance and leave the door slightly open so that moisture and odours are not trapped inside. It is recommended that you run a wash cycle with the dishwasher empty and then remove the plug from the socket, turn off the water supply and leave the door of the appliance slightly open. This will help the d oor seals to last longer and prevent odours from forming within the appliance.
The a ppl iance must be conne cted to th e w ater mai ns using new hos e-sets. The o ld hose -sets sho uld not be re used. Water pressure must be between 0,04 MPa and 1 MPa. If the pressu re is below t he minimum consult our Service Department for advice. 1 Pull the Aqua-Stop hose completely out from the storage compartment located at the rear of the dishwasher. 2 Tighter the screws of the Aqua-Stop hose to the faucet with thread 3/4inch. 3 Turn water full y on before starting the dishwasher.
Insert the drain hose into a drain pipe with a minimum diameter of 4 cm, or let it run into the sink, making sure to avoid bending or crimping. Use the special plastic support that comes with the appliance. The free end of the hose must be at a height between 40 and 100cm and must not be immersed in water.
Fuse blown, or the circuit breaker acted Replace fuse or reset circuit breaker. Remove any other appliances sharing the same circuit with the dishwasher Power supply is not turned on Make sure the dishwasher is turned on and the door is closed securely. Make sure the power cord is properly plugged into the wall socket. Water pressure is low Check that the water supply is connected properly and the water is turned on. Door of dishwasher not properly closed.
WARNING! The dishes were not loaded correctly. See notes in " Loading the Dishwasher ". The programme was not adequate. Select a more intensive programme. See" Wash Cycle Table ". Not enough detergent was dispensed. Use more detergent, or change your detergent. Items are blocking the path of spray arms. Rearrange the items so that the spray can rotate freely. The filter combination in the base of wash cabinet is not clean or is not correctly fitted. This may cause the spray arm jets to get blocked.
850 Height : 850mm Width : Depth : Voltage connected Load : Water pressure: 600mm 590mm see rating label 0.04-1.
