Use & care guide

ManualsBrandsWhirlpool ManualsCooktop8273166

Quick Reference

Table of Contents:

Pages

4 - 7

7 - 8

Installation Instructions

IMPORTANT:

Installer: Leave Installation Instructions with the homeowner.

Homeowner: Keep Installation Instructions for future reference.

Save Installation Instructions for local electrical inspector's use.

Part No. 8273166 Rev. B

CLO

TIMER

IMPORTANT:

Read and save these instructions.

If you need assistance:

Check your Use and Care Guide for a toll-free number to call or call

the dealer from whom you purchased this range. The dealer is listed

in the Yellow Pages of your phone directory under “Appliances —

Household — Major — Service and Repair.”

Call when you:

 Have questions about range installation or operation.

 Need to obtain the name and number of an authorized

service company.

When you call, you will need:

 The range model number.

 The range serial number.

Both numbers are listed on the model/serial rating plate located on

the frame behind the broiler drawer.

Before you start

Product dimensions

Cabinet dimensions/requirements

Electrical requirements

Gas supply requirements

Installation steps

Gas conversions

If range does not operate

If you need assistance/service

Moving the range

Back cover

30" Freestanding

Sealed Burner

Gas Range

with standard clean oven

Tip Over Hazard

A child or adult can tip the range and be

killed.

Connect anti-tip bracket to rear range foot.

Reconnect the anti-tip bracket, if the range

is moved.

Failure to follow these instructions can

result in death or serious burns to children

and adults.

WARNING

Summary of content (9 pages)

PAGE 1
Installation Instructions CLOCK 8.
PAGE 2
Before you start... Your safety and the safety of others are very important. We have provided many important safety message in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will be preceded by the safety alert symbol and the word “DANGER” or “WARNING”. These words mean: Product dimensions Grounded electrical outlet is required.
PAGE 3
Tools needed: Electrical requirements WARNING level 3/8" drive ratchet wood floor: 1/8" drill bit Phillips screwdriver concrete/ceramic floors: 3/16" carbide-tipped masonry drill bit (Hammer may be needed for anchors.) tape measure or ruler channel lock pliers 15/16" and 1/2" combination wrenches putty knife gloves safety glasses hand or electric drill pipe wrench Materials required: • gas line shutoff valve • 1/2" male pipe thread nipple for connection to pressure regulator • L.P.
PAGE 4
CLOCK TIMER 8.8:88 TIMER E D D Check cooktop burners for proper flame Plug power supply cord into grounded outlet Make proper gas connection A Remove shipping material. Remove oven racks and parts package. B C Install antitip bracket Secure range with anti-tip bracket C E Level range Check burner operation D Replace or close broiler drawer. (Roll-out broiler drawer shown is available on some models.
PAGE 5
C Operating position front leveling leg rear leveling leg 5. Remove cardboard shipping base from under range. Open broiler drawer. Use a 3/8" drive ratchet to lower rear leveling legs onehalf turn. Use channel lock pliers to lower front leveling legs one-half turn. Before moving range across floor, check that range is still on cardboard shipping base to protect floor covering. 6.
PAGE 6
E Check operation Electronic ignition system Check operation of oven burner Check operation of broil burner Cooktop and oven burners use electronic ignitors in place of standing pilots. When a cooktop control knob is turned to the “LIGHT” position, the system creates a spark to light the burner. This sparking continues until the control knob is turned to the desired setting. When the oven control is turned to the desired setting, a hot surface ignitor heats to a bright orange and ignites the gas.
PAGE 7
Gas conversions (from Natural gas to L.P. gas; or from L.P. gas to Natural gas) must be done by a qualified installer. WARNING Fire Hazard Shut off gas supply line valve. Make all conversions before turning gas supply valve back on. Failure to follow these instructions can result in explosion, fire or other injury. L.P. gas conversion 1. Complete installation sections A-C (Pages 4-5) before converting cooktop to L.P. gas.
PAGE 8
Natural gas conversion 1. Check that main gas supply line has been shut off and the power supply cord is disconnected. pressure regulator 3. reinstall Surface one of the orifice screws Burners: spud Remove burner spark electrode caps. Use a orifice spud Phillips or holder Quadrex screwdriver to remove the two screws holding range cooktop the burner head down. Lift the burner head off the cooktop to uncover the orifice spud holder. The orifice spud is recessed in the holder.
PAGE 9
If range does not operate: Check that the circuit breaker is not tripped or the house fuse blown. Check that the power supply cord is plugged into the wall receptacle. Check that gas line is turned on. See Use and Care Guide for troubleshooting list. If you need assistance: If you have questions about operating, cleaning or maintaining your range: Refer to Use and Care Guide. Call the Consumer Assistance Center.