Part No. 3369089 IMPORTANT: Installer: Leave Installation Instructions with the homeowner. Homeowner: Keep Installation Instructions for future reference, Save Installation Instructions for local electrical inspector’s use.
Before you start.. . Proper installation is your responsibility, Make sure you have everything necessary for correct installation. It is the responsibility of the customer to contact a qualified installer to assure that the plumbing and electrical installations are adequate and meet all national and local codes and ordinances Proper eiectncal, drain and water supply lines must be avai!able or must be installed as specified within shaded area.
2. Run flexible, armored or nonmetallic sheathed, copper cable (with grounding wire) from the fused disconnect, circuit breaker or junction box through the l/2” or larger cabinet hole to the dishwasher location. The cable must etiend 24” from the back wall. The hole cut through a wood cabinet should be sanded until smooth. The hole cut through a metal cabinet must be covered with a grommet (Part No. 3027971, available from your authorized dealer. A U-L.
Now start... with dishwasher ,’ in kitchen. T - 1~cabinet wall Ii v 1 water SUPPlY pipe +5’*+ Rough in water line to the dishwasher cabinet opening using one of the routing methods shown. Cut l/2-inch hole or larger in cabinet wall for water line. 2 n - ‘64 4 Cut a l/2-inch or larger hole I in the cabinet or floor for the electrical wiring to pass through. If this hole is cut in a wood cabinet, sand the hole until it is smooth.
Recommended drain hose connection methods: Drain hose to air gap to waste tee. 15 Check door for proper w operation. Door should close easily without slamming and open with its own weight. If necessary, close door and adjust both door springs by moving spring ends to different holes in base. clearance above t hap Do Not solder within 6” of plastic Drain hose to air gap to disposer. w at eT Failure to follow this instruction could result in product damage.
To change door color panel. To change access color panel .- (For models (For models so equipped) so equipped) Personal Injury Hazard Handle metal edges of panels carefully. Cut metal edges may cause personal injury or damage to other materials. 4. Hold door panel and spacer up. Insert trim piece and push down until it snaps in place. Slide door panel down. 1 Push up with thumbs near w each end of the access panel top trim to unsnap the front of trim. Remove the top trim and set it aside.
If the dishwasher is not operating properly.. . Check l l l l l these points: Is the door closed tightly ana latched securely? Has the cycle been set correctly to start the dishwasher? is the water turned on? Has a house fuse blown? Has electrical power been interrupted? Note: If the motor has stoppea because of overload, it will automatically reset itself within a few minutes. If after checking these points the dishwasher still does not run or complete a cycle, call for service.