Installation guide

ManualsBrandsWhirlpool ManualsWasherOfficial Whirlpool washer

Insta|iation

©©

[mst_||er: Leave Installation Instructions with the homeowner,

Hemeowner: Keep Instaihtion Instructions for future reference.

Save InstaIhtion Instructions for tocaI electrical inspector's use.

Your safety and the safety, of others are very important.

We have provided many important safety messagesin this manua[and on

your appliance.Always read and obey all safety messages.

This is the safety alert symbol.

This symbol alerts you to potential hazardsthat can kill or hurt you

and others.

Aii safety messageswiii foiiow the safety alert symbol and either the word

"DANGER"or "WARNING". Thesewords mean:

Youcanbe killed or seriously injuredif

you don't immediate[2follow instructions.

Youcan be killed or seriously injured if

you don't follow instructions.

All safety messageswill telI you what the potential hazard is, tetl you how to

reducethe chance of injury, andtell you what can happen if the instructions

are not followed.

Open lid and remove parts from

inside washer. Check that all parts

were included,

4 fiat water

hose washers

drain hose damp yellow damp

2 front leveling legs literature pack

with nuts (inside washer

Too|s needed:

_ge

[eve[

adjustable wrench or

9/16 open-end

wrench

Summary of content (5 pages)

PAGE 1
Your safety and the safety, of others are very important. Insta|iation We have provided many important safety messages in this manua[ and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. Aii safety messageswiii foiiow the safety alert symbol and either the word "DANGER" or "WARNING".
PAGE 2
Location of washer: C.eoiooa.oo where washer w,,, be,nsta,ed. Make sure you have everyth,ng necessary for correct installation. Proper imtalIation ao. cold The hot and cold water inlets on the back of the washer have 3/4 -11d/2 American hose coupling standard threads. Support: Floor must be sturdy enough to support washer weight (with water) of 315 pounds.
PAGE 3
[I QZCO)Z02] Level washer Cold water inlet valve X Attach inlet hoses to hot and cold water valves, Plug power supp_ cord into grounded outlet. Hot water inlet valve Attach inlet hoses to water faucets. Read and then remove [abel hose connection, Power cord is attached to shipping strap. Use yetlow damp to connect rigid and flexible drain hose sections. Secure drain hose to laundry tub or standpipe. Attach drain hose to drain Check that drain hose is proper length. connector.
PAGE 4
Drain hose Wet the inside end of the drain hose with tap water DO NOT USE ANY OTHER LUBRmCANT. Squeeze ears of drain hose clamp with pliers to open and place clamp over the end of the drain hose. Open clamp and push end of drain hose onto drain connector until hose contacts ribbed stop. Place clamp over area marked "clamp". Release clamp. e Standpipe or laundry tub dra|n system: Open yellow damp and slide over "hook" end of drain hose to secure the rubber and corrugated sections together.
PAGE 5
Turn on water faucets and check for leaks. Tighten couplings if there is leaking. DO NOT OVERTIGHTEN; this could cause damage to couplings. Guide. (Step 13) : (Step 7) ® Check that all parts are now installed. If there is an extra part, 9o back through steps to see which step was skipped. Need Ass|stance? o Read the Use and Care Start the washer and allow to complete 4 (Step 6) D Plug power supply cord into grounded outlet. • Check that you have all of your tools.