F 1 0 m < W a c
- 48 INCH FLEX. CABLE *F:OR A 36” OPEN OVEN DOOR HEIGHT FIGURE l--ROUGH-IN DIMENSIONS 28%” MINIMUM , IF 28-5/8” IS AVAILABLE THE CUTOUT SHOULD BE MADE 28-5/8”. DO NOT INSTALL THIS OVEN IN A BASE CABINET WITH A COUNTERTOP ABOVE IT. 1. CARPENTRY NOTE: Wire sizes and connections must conform with the fuse size and rate of the appliance in accordance with the National Electrical Code and local codes and ordinances. Do not use an extension cord.
1. If local codes permit connection of the frame grounding conductor to the neutral (white wire), connect the green and white wire from the supply cable of the appliance together and to the neutral (white) wire in the junction box. Connect the remaining wires from the supply cable, matching the colors, to the wires in the junction box. 3. INSTALLATION NOTE: Before installing the oven in the cutout, it may be helpful to remove the oven door. See details below. Insert appliance into cut-out.
With the door off, you will notice how the ends of the hinges slide into slots at the bottom corners of the door. To put the door back on, fit both bottom corners of the door over the ends of the hinges. Push the door down evenly, so neither corner gets ahead of the other. When it reaches the bottom, you can close the door. A safety latch will hold the door open until it is on correctly. 4. CHECKING CAUTION: Do not touch the elements. hot and you may get burned. A. 1.
