Installation Instructions

ManualsBrandsWhirlpool ManualsAir Compressor1157672

Part No. 1157672 Rev. D

IMPORTANT:

Read and save

these instructions.

( IMPORTANT:

Air

Conditioner

j Installer: Leave Installation Instructions

with the homeowner.

Homeowner: Keep Installation Instructions

1 s

for future reference.

ave Installation Instructions for local

electrical inspector’s use.

Summary of content (4 pages)

PAGE 1
L Part No. 1157672 Rev. D IMPORTANT: Read and save these instructions. ( j IMPORTANT: Installer: Leave Installation Instructions with the homeowner. Homeowner: Keep Installation Instructions for future reference. 1 s ave Installation Instructions for local electrical inspector’s use.
PAGE 2
Before you start.. . Grounded electrical outlet within reach of the power supply cord IS required. See Electrical requirements. ProDer installation is vour responsibility. Make sure you have everything necessary for correct installation. It is the customer’s responsibilitv to comDlv with the installation specific&i&s provided. Important: Observe all governing codes and ordinances. Order Through-the-Wall Mounting Kit, Port No. 1158268 from authorized parts distributor. 7/oly\ opening Electrical outlet
PAGE 3
Recommended method A single-phase, 6OHz. AC only, electrical supFjly is required on a separate circuit. A 15amp. time-delay fuse or circuit breaker is required. Copper wire (#14-gauge) is required. grounding Do Not, under any circumstances, remove the power supply cord grounding prong. For your personal safety, this appliance must be grounded. This appliance is equipped with a power supply cord having a 3-prong grounding plug. To minimize possible shock hazard.
PAGE 4
Insert the frame in the wall opening, Square and level frame. Nail frame securely to the wall studs. n 1 Remove the rear grille from the air conditioner and ~;--~ discard the grille. n 7 Place level on air conditioner in openinq. There should be a tilt t6 the outside of about one bubble. The air conditioner should be level from side to side. l Place the foamseal between the front edge of the air conditioner base and the bottom flange of the cabinet.