User's Manual

ManualsBrandsWGI Innovations ManualsCamera & PhotoGame Scouting Camera

Page 1 / Total 4

User Manual（For FCC Certification）

Product Serial Num： Product Name：

LO8

File Serial Num： edition：

Compiled by JNan Lao Apr 6

,2012 Reviewed by Stephen Apr 6

, 2012

Summary

ThepicturebelowisLO8realproductphoto.Thereisabatterycompartmentinbothsides,inwhichyou

canputbatteriesafterscrewingupthecoveratthebottom.Allthebatteriesshouldbeputwithpositivepole

intheoutside.OpentheSDcardholder,youcanseearesetkey,aminiUSBandaSDcartslot.

LO8realproductphoto

BatterycompartmentfilledwithbatteriesSDcardslot

Summary of content (4 pages)

PAGE 1
Product Serial Num： User Manual（For FCC Certification） Product Name： LO8 File Serial Num： edition： Summary The picture below is LO8 real product photo. There is a battery compartment in both sides, in which you can put batteries after screwing up the cover at the bottom. All the batteries should be put with positive pole in the outside. Open the SD card holder, you can see a reset key, a mini USB and a SD cart slot.
PAGE 2
User Manual（For FCC Certification） Product Name： LO8 File Serial Num： Product Serial Num： edition： UI mode (PIC 1) (PIC 2) Long press the POWER button to boot up, and go to the interface in(PIC 1). Press OK to go to the interface in(PIC 2). Press UP/DOWN/LEFT/RIGHT button to choose the third option IMAGE TYPE, press OK to the setting mode. You can press LEFT/RIGHT button to make the option STILL(take photos) or VIDEO(take videos) highlighted. Then press OK to save the setting and go to next setting.
PAGE 3
Product Serial Num： User Manual（For FCC Certification） Product Name： LO8 File Serial Num： edition： □ Day □ Night PIR Sense □ Hi ■ Med □ Lo PIR sensitivity. Picture ■ Regular □ Wide The length-width ratio of the photos to be taken. Regular is 4:3; Wide is 16:9.
PAGE 4
Product Serial Num： you set in the UI mode. User Manual（For FCC Certification） Product Name： LO8 File Serial Num： edition： Tip: Pressing the RESET button to reset the camera, it will take photos after going to the standby mode . You can take videos if only change the PIR Mode to Video. Attention: 1. You should plug in the SD card before taking photos or videos. 2. The red LED will flash if you trigger the infrared sensor in the first 1.5 minutes of this mode. After 1.5 minute, the function will be off.