Installation & Assembly (Panels into Studs)

Installation & Assembly
Panels into Studs
Warning: Due to sheet metal edges, We strongly recommends the use of gloves while installing metal pegboard
panels
Our pe gboa rds and too l
boards are designed to be
mounted directly into
framing ( or through drywall
into framing) with the
screws provided.
Attachment with the
included screws to any
other surface is not
recommended without
utilizing proper ancho rs or
otherwise consulting with a
knowledgeable hardware
representative prior to
installation
Step 1: Align edge of wa II pan el with centerline of stud.
If mounting into studs through drywal I, use a stud find er or
small nail to locate the stud center
Slots should be vertical for use with wall accessories
Step 2: Mark the (6) mounting hole positions on wall or stud
Step 3: M ave pane I and dri II 1 /8" d ia meter hales at marked positions for
provided mounting screws
Step 4: Attach panel to wall with the (6) #12 x 1-1 /4" screws provided.
Do not fully tighten screws until al I screws have been started and
the panel is level
Quick Tip: Mounting to surfaces other than studs or drywall is typically fairly
similar and simple. It might only require a trip to your local hardware store for
the correct fasteners