Contents Safety and warnings.......................................................................................2-3 Introduction..................................................................................................4 Stand installation guide..................................................................................5 Installation....................................................................................................6-9 Remote Control...........................................
SAFETY AND WARNINGS IMPORTANT SAFETY INSTRUCTION CAUTION 1) Read these instructions. 2) Keep these instructions. 3) Heed all warnings. 4) Follow all instructions. 5) Do not use this apparatus near water. 6) Clean only with dry cloth. 7) Do not block any ventilation openings, install in accordance with the instructions. 8) Do not install near any heat sources such as radiations, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
SAFETY AND WARNINGS High voltages are used in the operation of this television receiver. Do not open the cabinet. Refer servicing to qualified service personnel. Never stand on, lean on, or suddenly push the television or its stand. You should pay special attention to children. Serious injury may result if it falls. To prevent fire or electrical shock hazard, do not expose the television receiver to rain or moisture. Do not place your television on an unstable cart, stand, shelf or table.
INTRODUCTION Main features Accessories Integrated ATSC TV tuner for HDTV broadcast reception High brightness provides a vivid and brilliant picture ■ Deeper blacks and brighter whites with high contrast ■ Wide Screen aspect ratio (16:9) for a complete home theater experience ■ HDMI input for true digital connection ■ VGA port for connection to PC ■ Built-in stereo speaker system ■ Full-function Remote Control Power Cable..................................... 1 Infrared Remote Control...................
STAND INSTALLATION GUIDE This STAND INSTALLATION GUIDE is provided to help you easily install the stand. Please carefully follow Step 1 through Step 3. Open the box and find the parts Open the box and find the following parts. - Stand x1 pc - Screws x 4 pcs Screws Packing Stand TV Stand Packing Place the Stand on the TV 2. Place the Stand on the TV as shown below. 1. Place the TV with the display side down on a table or desk (flat, totally clean surface).
INSTALLATION Side panel Front panel 3 SOURCE 1 MENU 2 CH+ 1 3 CH- 2 VIDEO VOL+ 4 VIDEO 5 L AV2 VOLSTANDBY R 30 1: Remote control sensor. 2: Indicator LED: GREEN RED 6 L 7 R 8 30 1. SOURCE: Display the input source menu. 2. MENU: Display main MENU. 3. CH+/CH-: In TV mode, press "CH+" or "CH-" to change the channel up and down. In MENU mode, press "CH+" or "CH-" to select items in standby mode, press "CH+" or "CH-" to turn on the TV. 4. VOL+/VOL-: Adjust sound level.
INSTALLATION PC STEPS: Be sure both the TV and computer are powered off. 1. Connect a VGA and audio cable. 2. Connect the power cord. 3. Turn on the TV and switch to VGA mode. 4. Turn on the PC. HDMI 1 HDMI 2 VGA INPUT Pr COMPONENT Pb INPUT AV1 AUDIO INPUT Y L HEADPHONE PC AUDIO INPUT COAXIAL RF INPUT AC INPUT 100-240V~50/60Hz R PRESET MODE RESOLUTION V.Freq.(Hz) H.Freq.(KHz) 1 720*400 70 31.47 2 640*480 60 31.47 3 640*480 75 37.50 4 800*600 60 37.88 5 800*600 75 46.
INSTALLATION ANTENNA Note: Aerial connections:IEC(female). Input impendance:75 unbalanced.
INSTALLATION AV EQUIPMENT There are two HDMI ports located on the back of your TV. You can connect a Blu-ray player, DVD player, or other video equipment through these ports. There is one component (Y, Pb, Pr) and two composite (AV) video input located on the back of your TV. You can connect a VCR, cable box, or other video equipment to these jacks. Please see the diagram below. You may also need to refer to the owner's manual of the device that you are trying to connect.
REMOTE CONTROL 1: POWER To turn the TV on. 2: NUMBER KEY For direct access to channels . 3: Displays the main on-screen menu. 4: CURSOR To move within the menu. 5: EXIT To exit the menu. 6: VOL+/To adjust sound level. 7: P .M To switch picture mode. 8: Press to display and select the available video sources. 9: MUTE To disable or enable the sound. 10: RECALL To access the previously viewed channel. 11: ENTER Confirms selection. 12: TV DISPLAY Displays/removes the program information 13: S.
OPERATION 1. PICTURE MENU 3. SETUP MENU The first item of the MENU is PICTURE MENU. You can adjust picture effect here, such as contrast, brightness, etc. Press to select, press to adjust, press MENU to exit. The third item of the MENU is SETUP MENU. You can setup system here. Press to select, press to adjust, press MENU to exit. Note: Restore Default: Reset all the settings to default value.
OPERATION Change Password: Press button, the screen will display as follow: Content Rating Content L D FV V S (Adult (Sexually (Fantasy (Violence) (Sexual violence) situation) language) suggestive dialog) TV-Y (All children) TV-Y7(Direct to Suggested order children) TV-G(General age X audience) TV-PG(Parental Guidance suggested) X X X X TV-14(Parents strongly cautioned) X X X X TV-MA(Mature audience only) X X X 1).Old password: Input the old password 2).
OPERATION E C Exempt: Includes news, sports, documents and other information programming: talk shows, music videos, and variety programming. Children: Intended for younger children under the age of 8 years. Pays careful attention to themes that could threaten their sense of securityand well-being.
OPERATION 3.4 Menu Settings You can adjust the Menu Settings here. Press to select, press to adjust, press MENU to exit. 1). Air/Cable: select Air TV signal and cable TV signal. 2). Auto Scan: If it's the first time you use the TV, you should scan all the TV channels first, press the button to confirm, you will see the menu: 3.5 VGA Settings: When PC Mode is available.