INSTRUCTION MANUAL 24” Upholsterd Nail Head Bar Stool SKU: ID401-24
CARE & MAINTENANCE △ Clean the dust with a soft cloth △ Do not store in extremely wet environment. HARDWARE 1 Flat washer 2 8PCS Lock washer 3 4 Allen Key 1PC 8PCS 5 Screws Self-tapping screw M8x60MM M4.5x45MM 8PCS 8PCS PARTS A B Seat 2PCS 1PC C Legs No. 2 2PCS Legs No.
PRODUCT ASSEMBLY 1 B C 2 B 1 C 1 2 Longer D D C B 2 1 Shorter E D E Longer Shorter A Put chair back on a clean flat surface. Please note put the legs on correct hole site as shown in the diagram 2 3 80% 4 2 1 Align front legs in the seat pad as shown in the diagram. Using SCREW (4) with Washer (#1,2) . DO NOT FULLY TIGHTEN. First HAND tighten then tightened using key (3) up-to 60-80% only at this stage.
PRODUCT ASSEMBLY 3 5 Using your own screwdriver 100% lock Self-tapping Screw (5) as shown in the diagram 4 Put chair in the upright position and SIT ON THE CHAIR to press downwards on the seat pad ensuring that all 4 feet touch the ground and chair is leveled. Proceed to tighten all screws making sure the chair remains level when tightening. Check that all screws are tight on a regular basis to ensure chair remains level and secure. Also you can using adjustable feet to keep four legs level .
PRODUCT ASSEMBLY 5 C B C 1 2 E B 2 D 1 E D A Please recheck all parts with correct position after assemble chair , Then close black fabric cover 6 Page 4 of 4
