User Instructions

ManualsBrandsWesthold ManualsElectronicsRace Car Transmitter

Installation Instructions – Hard Wired Transmitter

1. Strip the leads back to expose the copper wire. Be careful not to damage

the wire when stripping.

2. Attach one lead to +12 volts and the other lead to the body frame of the

vehicle that the ground (negative) terminal of the battery is connected to. It

does not matter whether the red or black lead is connected to +12 volts and

ground as long as one is at +12 volts and the other is grounded.

Current drawn by the transmitter is low. However the transmitter should be

connected in such that the transmitter is disengaged when the vehicle is not

running.

**Do not exceed +14 volts or the transmitter may be damaged.

3. When power is delivered to the transmitter both the red and green LED

lights will turn on momentarily. The red LED will shut off and the green

LED light will flash approximately once a second to indicate that the

transmitter is operational.

If only the red LED light is on, it indicates voltage is too low for normal

operation. Do not allow the voltage to go below +9 volts.

Description Specification

Voltage +14 > Voltage > +9V

Current < 30 milliamps

Summary of content (3 pages)

PAGE 1
Installation Instructions – Hard Wired Transmitter 1. Strip the leads back to expose the copper wire. Be careful not to damage the wire when stripping. 2. Attach one lead to +12 volts and the other lead to the body frame of the vehicle that the ground (negative) terminal of the battery is connected to. It does not matter whether the red or black lead is connected to +12 volts and ground as long as one is at +12 volts and the other is grounded. Current drawn by the transmitter is low.
PAGE 2
Transmitter Mounting 1) The label side should face down toward the track. 2) No metal should be between the label and the track. This is a poor orientation and will result in inconsistent performance. • Label side of the transmitter faces down toward the track. Note: There are other systems that use a different orientation such as the one on the right. Be careful about mixing the orientations. • No metal or carbon fiber between transmitter and track. The transmitter must have a clear shot to the ground.
PAGE 3
FCC Notice FEDERAL COMMUNICATIONS COMMISSION RADIO AND TELEVISION INTERFERENCE STATEMENT Changes or modifications not expressly approved by Westhold Corporation could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received including interference that may cause undesired operation.