Ibex-RT-310 and Ibex-RT-320 Series User Guide Contents 1 2 3 4 5 6 7 General Information ........................................................................................................................ 4 1.1 Legal Information .................................................................................................................... 4 1.2 About This Guide ..................................................................................................................... 4 1.
Ibex-RT-310 and Ibex-RT-320 Series User Guide Westermo Network Technologies 3
Ibex-RT-310 and Ibex-RT-320 Series User Guide 1 General Information 1.1 Legal Information The contents of this document are provided “as is”. Except as required by applicable law, no warranties of any kind are made in relation to the accuracy and reliability or contents of this document, either expressed or implied, including but not limited to the implied warranties of merchantability and fitness for a particular purpose.
Ibex-RT-310 and Ibex-RT-320 Series User Guide 2 Safety and Regulations 2.1 Warning Levels Warning signs are provided to prevent personal injuries and/or damages to the product.
Ibex-RT-310 and Ibex-RT-320 Series User Guide 2.2 Safety Information Before Installation: Read this manual completely and gather all information available on the product. Make sure it is fully understood. Check that your application does not exceed the safe operating specifications for the product. This product relies on convection cooling. Make sure that it is installed so that the ambient temperature is within the specified temperature range, e.g.
Ibex-RT-310 and Ibex-RT-320 Series User Guide WARNING – RADIO PRODUCTS Observe the usage limitations of radio products at filling stations, in chemical plants, in systems with explosives or potentially explosives locations. The devices may not be used in airplanes. Exercise particular caution near personal medical aids, such as pacemakers and hearing aids. Never perform work on the antenna system during a thunderstorm.
Ibex-RT-310 and Ibex-RT-320 Series User Guide 2.3 Care Recommendations Follow the care recommendations below to maintain full operation of the product and to fulfill the warranty obligations: Do not drop, knock or shake the product. Rough handling above the specification may cause damage to internal circuit boards. Use a dry or slightly water-damp cloth to clean the product. Do not use harsh chemicals, cleaning solvents or strong detergents. Do not paint the product.
Ibex-RT-310 and Ibex-RT-320 Series User Guide 2.5 Compliance Information REGULATORY NOTICE Any changes or modifications shall be approved by the party responsible for compliance. If not, users could void the user's authority to operate the equipment. Country code and antenna gain needs to be set properly for correct functionality in the installed country. 2.5.
Ibex-RT-310 and Ibex-RT-320 Series User Guide 2.5.2 United States - FCC The enclosed device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (i.) this device may not cause harmful interference and (ii.) this device must accept any interference received, including interference that may cause undesired operation. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
Ibex-RT-310 and Ibex-RT-320 Series User Guide This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance of 20 cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.
Ibex-RT-310 and Ibex-RT-320 Series User Guide 2.5.6 Europe - Simplified Declaration of Conformity Hereby, Westermo declares that this product is in compliance with applicable EU directives and UK legislations. The full EU declaration of conformity and other detailed information is available at www.westermo.com/support/product-support.
Ibex-RT-310 and Ibex-RT-320 Series User Guide 3 Product Description 3.1 Product Description The Ibex-RT-310 and Ibex-RT-320 series can be configured as a WLAN Access Point, Client or Bridge. It is designed for onboard and infrastructure Wi-Fi installations in public transport and harsh environments. The 802.11 WLAN radio is operating at 2.4 GHz and 5 GHz frequency bands. DC Power Supply X1 Gigabit Ethernet CPU WLAN 802.
Ibex-RT-310 and Ibex-RT-320 Series User Guide 3.3 Hardware Overview 3.3.1 Front Side View No. 1 2 3 4 5 6 7 Description LED indicators Gigabit Ethernet ports X1 and X2 Protective earth terminal Power input DC Front side label Warning symbol for surface temperatures above +60°C Antenna ports A1 to A3 Figure 4 Location of interface ports and LED indicators 3.3.2 Front Side Label Ibex-RT-320-LV EU Power: 24VDC, 0.
Ibex-RT-310 and Ibex-RT-320 Series User Guide No. 1 Description QR code 2 Manufacturing date 3 4 Serial number Article number Remarks The data matrix is: AAAA-AAAARR-1-VV-SSSSSSSS-YYWW AAAA-AAAA = Article number RR = Region code VV = Product revision SSSSSSSS = Serial number YY = Manufacturing Year WW = Manufacturing Week The Date Format is: YYWW YY = Manufacturing Year WW = Manufacturing Week AAAA-AAAARR AAAA-AAAA = Article number RR = Region code Figure 5 Front side label content 3.3.
Ibex-RT-310 and Ibex-RT-320 Series User Guide No. 1 2 3 4 Description Antenna 1000Base-T Grounding point Power Figure 7 View to interface ports 3.4 Connector Information 3.4.
Ibex-RT-310 and Ibex-RT-320 Series User Guide PoE connection on X2 (Ibex-RT-310-LV and Ibex-RT-320-LV only) Position Device mode A Device mode B 1 +DC 2 +DC 3 -DC 4 -DC 5 -DC 6 -DC 7 +DC 8 +DC Table 6 Ethernet X2 PoE connection NOTE PoE is supported on X2 for the LV product variant only. NOTE If the Ethernet function is not used, the protective dust cap which is part of the delivery must be closed to protect the interface from water or dust ingress. 3.4.
Ibex-RT-310 and Ibex-RT-320 Series User Guide 3.5 LED Indicators LED DC OPR ERR X1 X2 Description Power status Operation status Error status Ethernet status for X1 port Ethernet status for X2 port Table 7 LED Indication NOTE Refer to management guide for detailed LED status indication. 3.6 Factory Reset To reset the product into factory default settings, a reset adapter is needed which is plugged into one of the Ethernet ports X1 or X2 during startup. Art. no.
Ibex-RT-310 and Ibex-RT-320 Series User Guide Figure 8 Dimensional drawing 4 Installation 4.1 Mounting The product is fixed with the four fixing points located at the corners of the product. M5 or M6 screws are used for the fixation of the product. The screws are tightened with min. 3.0 Nm (fixing screw ISO 898/1, quality class 8.8). NOTICE All four specified fixing points must be used for fixing. The installation surface should be flat to have all fixing points connected to the surface.
Ibex-RT-310 and Ibex-RT-320 Series User Guide NOTE Unused connectors must be covered by a protective cap (delivered with the product), tightened to the specified torque in order to fulfill the specified ingress protection code. 4.2 Earth Connection For correct function, the earth connection at the grounding point needs to be properly connected to a solid ground. An M5 grounding screw at the housing is used for grounding. A short wire with a cross section of at least 4 mm2 shall be used.
Ibex-RT-310 and Ibex-RT-320 Series User Guide Figure 10 Installation with reduced natural convection airflow Figure 11 Installation with natural convection airflow When operating the device at high ambient temperatures, it is recommended to mount the device to a metallic base plate to improve the heat dissipation. The base plate increases the surface to spread the heat.
Ibex-RT-310 and Ibex-RT-320 Series User Guide Figure 12 Improved heat transfer based on fixing plate NOTICE Limited air flow is rising the device temperature and may lower the upper limit of the operating temperature range. NOTICE Temperature is dependent on the operational parameters, like RF output power, amount of traffic. NOTICE This product has integrated temperature sensors for monitoring the internal device temperatures.
Ibex-RT-310 and Ibex-RT-320 Series User Guide CAUTION - HOT SURFACE Be aware of that the surface of this product may become hot. When it is operated at high temperatures, the external surface may exceed Touch Temperature Limit according to the product's relevant electrical safety standard. This product complies with Touch Temperature Limits throughout its operational temperature range.
Ibex-RT-310 and Ibex-RT-320 Series User Guide 5 Specifications 5.1 Interface Specifications DC, Power port Connector Rated voltage Operating voltage Rated current Rated frequency Inrush current, I²t Ibex-RT-310-LV and Ibex-RT-320-LV M12 A-coded male 24 VDC 16 to 30 VDC 0.6 A DC 39 mA2s at 24 VDC Startup current1 Polarity Redundant power input Conductor cross section (flexible) Cable temperature rating Shielded cable 2 x nominal current Reverse polarity protected No > 0.
Ibex-RT-310 and Ibex-RT-320 Series User Guide NOTICE To avoid damages on the Ethernet interfaces, ensure that the far end side of the Ethernet cable shield itself is connected to protective earth. Antenna WLAN (A1, A2) Connector Direction Cabling Conductive chassis WLAN interface WLAN frequency bands Transmitting power Ibex-RT-310 Transmitting power Ibex-RT-320 QMA female Transmit and receive 50-ohm coaxial cable and WLAN antenna required Yes High power 3x3 MIMO 802.11n Access Point / Client 2.400 to 2.
Ibex-RT-310 and Ibex-RT-320 Series User Guide 5.
Ibex-RT-310 and Ibex-RT-320 Series User Guide Environmental phenomena Temperatures Humidity Altitude MTBF Vibration Shock3 Basic standard EN 60068-2-1 EN 60068-2-2 EN 60068-2-14 EN 60068-2-30 IEC TR 62380 MIL STD 810, M514.
Ibex-RT-310 and Ibex-RT-320 Series User Guide 6 Abbreviations and Terms Abbreviation AM AREMA AWG BPSK CAT5e CE CPU DC EMC EN ERR ESD ETSI FLOSS FCC HV IEC IC ID I/O IP ISO LAN LED LV MIMO MTBF MTTR OPR PM PoE QMA QR RF TNV SN SNMP VPN WebGUI WeConfig WEEE WLAN Description Amplitude Modulation American Railway Engineering and Maintenance-of-Way Association American Wire Gauge Binary Phase Shift Keying Category 5 Enhanced Cable Conformité Européenne Central Processing Unit Direct Current Electromagnetic Co
Ibex-RT-310 and Ibex-RT-320 Series User Guide 7 Revision Notes Revision Rev. D Date 2021-03 Rev. E 2021-05 Westermo Network Technologies Product illustrations updated to blue, text in illustrations removed, Westermo address updated, chapter 2.5.