User's Manual

UltraLine II VDSL– Draft 1
030-300237 Rev. A
8/8/06
030-300237 Rev. A 77 August 2006
User Guide
UltraLine II VDSL Gateway (Model 826010)
Wireless Basic Configuration
Wireless Operation Factory Default = Enabled
Displays the current setting of the Gateway’s wireless operation.
When disabled, no wireless stations will be able to connect to the Gateway.
Network Name (SSID) This string (32 characters or less) is the name associated with the Gateway. To
connect to the Gateway, the SSID on a Station card must match the SSID on the
Gateway card or be set to “ANY.” (Note: If the SSID on a Gateway is hidden, at
the station card you must manually type the SSID of the Gateway to which you
are trying to connect.)
Channel The AP transmits and receives data on this channel. The number of channels to
choose from is pre-programmed into the AP card. The Gateway transmits and
receives data on this channel. Station cards do not have to be set to the same
channel as the AP; the station cards scan all channels and look for the Gateway
with the correct SSID.
Possible Responses:
1 through 11
Mode This setting allows station to communicate with the Gateway.
Possible Responses:
Mixed: Station using any of the 802.11b and 802.11g rates can communicate with
the Gateway.
Legacy Mixed: Same as Mixed, but also allows older 802.11b cards to
communicate with the Gateway.
11b only: Communication with the Gateway is limited to 802.11b
11g only: Communication with the Gateway is limited to 802.11g
Frameburst Mode If enabled, additional algorithms are used for increased throughput.
If Disabled, this feature will not be activated.
Hide SSID If enabled, the Gateway will not broadcast the SSID. To connect to the Gateway,
each Station must configure its SSIDs so that it matches the Gateway’s Network
Name (SSID).
If Disabled, this function will not be activated.