Instructions / Assembly

ManualsBrandsWestek ManualsElectrical15 Amp Indoor Daily Timer with Non-Removable Pins

Questions?, ¿Preguntas? 201.661.9945

Saddle River Executive Centre,

One Route 17 South, Saddle River, NJ 07458

www.amertac.com

Made in China

Instruction Manual & Warranty

Indoor

1-Outlet Daily Timer

Limited One Year Warranty

AmerTac™ warrants this product to be free from defects in material and workmanship for a period of one

year from the date of purchase. AmerTac’s obligations are limited to repairing or replacing any defective unit

and are effective only if such units are returned within one year of the purchase date to AmerTac, 250 Boulder

Drive, Breinigsville, PA 18031. Warranty void if damage is due to misuse or improper installation. In no

circumstance will AmerTac be liable for consequential or incidental damages relating in any way to this product.

Represents timer that will come on

at 7:30PM and shut off at 10:30PM.

TIME

MIDNIGHT

NOON

TM01DHB

Setting On/Off Periods: Timer can set up to 48 On/Off commands a day. Using your finger, pen or screwdriver,

pull up all pins that correspond to desired “Off” time. For desired “On” time, make sure pins are pushed down.

Each pin represents 30 minutes: 2 pins = 1 hour.

Setting Time: Turn dial clockwise until triangular pointer is pointing at actual time. Be sure switch on top of

unit is set to TIMER ON.

Connection: Once desired On/Off times and actual time are set, plug timer into wall outlet, and plug lamp/device

into timer. Be sure wall outlet and lamp/device are turned on. Timer will start to operate, turning lamp/device

On/Off according to pre-set commands.

Manual On/Off: Pre-set On/Off commands can be interrupted by using manual override switch located on top

of unit. When switched to OUTLET ON, connected lamp/device is switched on permanently. To reactivate timer’s

control of lamp/device, turn lamp/device switch on and set timer’s override switch to TIMER ON.

In case of power failure, reset timer as explained above.

RATINGS:

125V~, 60Hz

15A, 1875W Resistive

10A, 1250W Tungsten

PRECAUTIONS:

- For indoor use only.

- Do not use with any device which exceeds capacity of timer.

- Always ensure that device plug is fully inserted into timer.

- If timer needs cleaning, unplug and wipe with a dry cloth.

- Do not immerse in water or any liquid.

FAN HEATERS AND HEATERS WITH EXPOSED ELEMENTS SHOULD NOT BE CONNECTED TO TIMERS.

Summary of content (3 pages)

PAGE 1
TM01DHB Instruction Manual & Warranty Indoor 1-Outlet Daily Timer Setting On/Off Periods: Timer can set up to 48 On/Off commands a day. Using your finger, pen or screwdriver, pull up all pins that correspond to desired “Off” time. For desired “On” time, make sure pins are pushed down. Each pin represents 30 minutes: 2 pins = 1 hour. Setting Time: Turn dial clockwise until triangular pointer is pointing at actual time. Be sure switch on top of unit is set to TIMER ON.
PAGE 2
TM01DHB Manual de instrucciones y garantía Interior Temporizador diario con 1-tomacorriente Cómo fijar los períodos de Encendido/Apagado: El temporizador puede configurar hasta 48 comandos de Encendido/Apagado al día. Con su dedo, bolígrafo o destornillador, tire hacia arriba de todas las clavijas que correspondan a la hora de "Apagado" deseadas. Para la hora de “Encendido” deseada, asegúrese que las clavijas se encuentren abajo. Cada clavija representa 30 minutos: 2 clavijas = 1 hora.
PAGE 3
TM01DHB Manuel d’instructions et garantie Intérieur Minuterie quotidienne à 1 prise Configuration des périodes D’ACTIVATION/DÉSACTIVATION : Le minuteur peut configurer jusqu’à 48 commandes ACTIVER/DÉSACTIVER par jour. À l'aide de votre doigt, d’un stylo ou d’un tournevis, tirer sur toutes les tiges qui correspondent à l'heure de « désactivation » désirée. Pour l’heure d'« activation » désirée, vérifier que les tiges sont enfoncées.Chaque tige représente 30 minutes.