Instructions / Assembly
40590
Wire Light to Transformer
Address Light
Transformer
Doorbell Doorbell Chime
Existing Doorbell Wiring
Application of Vinyl Numbers
Doorbell Transformer Installation Instructions
Optional Plug-in Power Supply - Sold Separate
Plan your desired distances between numbers on the address light to ensure the best appearance. For 5-digit
addresses, the spacing looks best approximately ¼” inch apart; 4 digits and less look best approximately ½” inch apart.
In a spray bottle, combine one cup of water with 3 to 5 drops of dish soap. Mix together thoroughly. Generously spray
the soapy water solution onto the address light lens surface to allow the numbers to slide easily without sticking.
Remove your desired number decals from the sheet and spray the soapy water solution onto the adhesive back of each
number decal. Place the number decals onto the lens surface of the address light and align the bottoms using the small
raised line at the bottom of the lens.
Start by aligning the middle number in the center of the lens surface. Then, adjust the spacing of the other decals until
you are satisfied with the appearance. Use a soft paper towel to press and wipe down each decal to remove the excess
soapy water solution, allowing the decals to adhere to the address light lens.
Separate the ends of the solid black wire (negative) and black with white dashes wire (positive) to allow enough length
for a secure connection to your doorbell transformer. Remove ½” of insulation from the end of both wires.
Turn off the power to your doorbell transformer and loosen both screw terminals.
Connect the end of the solid black wire (negative) to the screw terminal housing the wire running from the transformer to
the doorbell. Connect the end of the black wire with white dashes (positive) to the screw terminal housing the wire
running from the transformer to the doorbell chime. Tighten screws back into terminal.
Turn back on the power. (Remember your new address light only works in the dark to save money and energy.)
Install your light using the included screws, and run the wires through the small clips on the back in the direction you like.
1.
2.
3.
4.
1.
2.
3.
4.
5.
©2020 AmerTac™ Email:CustomerService@amertac.com Phone: (610) 336-1330 Fax: (610) 336-1336
Address Light Installation Instructions