Installation Guide

Separate the ends of the solid black wire (negative) and black with
white dashes wire (positive) to allow enough length for a secure
connection to your doorbell transformer. Remove ½” of insulation from
the end of both wires.
Match the solid black wire from the address light to the solid black
wire of the Plug-In Power Supply and connect by screwing on one of
the provided weatherproof orange wire caps in a clockwise direction.
Match the black wire with white dashes from the address light to the
black wire with white dashes of the Plug-In Power Supply and
connect by screwing on one of the provided weatherproof orange wire
caps in a clockwise direction.
Plug the Power Supply into your wall outlet and check for power.
(Remember your new address light only works in the dark to save
money and energy.)
Install your light using the included screws, and run the wires through
the small clips in the back in the direction you like.
1.
2.
3.
4.
©2020 AmerTac™ [e-mail] Phone: [phone]
Plug-in Power Supply Installation Instructions
40590
Transformer
Wire Connector
Address Light