Assembly Instruction

branch mirror
mounting instructions
Page 1 of 19566464/9566514/8395592 - 04.03.08
CARE INSTRUCTIONS
Hardware may loosen overtime. Periodically check that all connections are tight.
Wipe with a soft, dry cloth. To protect  nish, avoid the use of chemicals and household cleaners.
NOTE: Stud mounting recommended.
1
22
2
6
2
drywall anchor 2x
screw 2x
A
B
1. Hold mirror at desired location. With a pencil, mark on wall the top
outside corners of the mirror. These marks will be used to determine
the location of the mounting hardware.
2. Measure down from the top of the mirror to the top of the D ring .
Measure in from the side of the mirror to the top of th e
D ring. Record these measurements on the wall, using the
marks in step 1 as a guide. Align the two measurements until they
intersect. This is the insertion point of the mounting hardware. Use
a carpenter's level to ensure the mirror will be level.
3. For stud mounting: skip to step 4. For drywall mounting: using a
Philip's head screwdriver, insert the drywall anchors (A) into the
wall at the insertion points. Press and turn clockwise until anchors
are flush with the wall.
4. Insert screws (B) into the anchors or at the insertion points, leaving
approximately 1/2" between the back of the screw head and the wall.
5. Align D ring over the screw heads.
6. Slide the mirror down until it rests on the screws. Tighten or loosen
screws as needed to fit the mirror snugly against the wall .
!
For drywall mounting, use anchors with screws.
For stud mounting, use screws only.
3-5
A
B
Use proper hardware for your wall type. For
drywall mounting we reccommend using hollow
wall anchors (#6-32) and 2” metal screws. When
in doubt, consult your local hardware store.
For your safety, assembly by two people is
strongly recommended.