Assembly Instruction

ManualsBrandsWest Elm ManualsAccessoriesWest Elm Apex Tower

apex tower

assembly instructions

Page 1 of 69756131/9756149- 01/13/09

! Tools required:

! Do not throw away packaging materials until assembly is complete.

! Assemble this item on a soft surface, such as cardboard or carpet, to protect ﬁ nish.

! Proper assembly of this item requires 2 people.

cam bolts 14x

Hardware

cam locks 14x

wall anchors 2x

screws 2x

Summary of content (6 pages)

PAGE 1
apex tower assembly instructions ! Tools required: ! Do not throw away packaging materials until assembly is complete. ! Assemble this item on a soft surface, such as cardboard or carpet, to protect finish. ! Proper assembly of this item requires 2 people.
PAGE 2
apex tower assembly instructions Parts B A top rail 1x right side 1x C D top shelf 1x 2nd shelf 1x F E 2nd to bottom shelf 1x middle shelf 1x G H bottom shelf 1x bottom rail 1x I left side 1x 9756131/9756149- 01/13/09 Page 2 of 6
PAGE 3
apex tower assembly instructions 1. Lay both side rails (A) & (I) on a clean smooth surface such a carpet or cardboard. Insert can bolts (1) into the holes shown in the drawing. I 1 A 2. Layout shelves in the order that the drawing shows. Insert cam lock (2) into bottom of shelves as the drawing shows. Align holes in side of shelves with the cam bolts (1). Align top and bottom rails with the holes in the side rails. Press together firmly.
PAGE 4
apex tower assembly instructions 3. Install the other side rail. Insert cam locks (2) into the holes shown in the drawing. Press the side rail firmly down against the shelves and rails. Tighten all cam locks (2) with phillips head screwdriver.
PAGE 5
apex tower assembly instructions 4. Once you have decided where to put your apex tower you must install the hanging hardware. Set the tower into final position against the wall. Make sure it is level and sitting flush on the floor. Make a small mark at the top and the sides of the top. You will have to measure from these marks. Move the tower unit. Measure the distance from the end of the side rail to the center of the hole. Now measure over from your mark the same distance. Make another mark.
PAGE 6
apex tower assembly instructions 5. Once you have double checked your measurements you will need to screw a wall anchor (3) into the center of both marks. Screw clockwise until the anchor is flush with the wall surface. Next insert a screw (4) and tighten until about 1/2” sticks out of the wall. Place tower back into position aligning screws with the holes in the back of the top rail. Left and press tower onto screws. Slide down to lock onto screws.