User manual WERET Wireless Charger IC-1 V 1.
Safety Read these simple guidelines. Not following them may be dangerous or illegal. INTERFERENCE All wireless devices may be susceptible to interference, which could affect performance. QUALIFIED SERVICE Only qualified personnel may install or repair this product. BATTERIES, CHARGERS, AND OTHER ACCESSORIES Use only batteries, watch , and other accessories approved by WERET for use with this device. Do not connect incompatible products. KEEP YOUR DEVICE DRY Your device is not water-resistant. Keep it dry.
All parts USB cable Charging Area Indicator light 1 USB connector 2 Charging area for charging the watch 3 Charging and notification indicator light
Charge your WERET watch 1. Connect the charging plate to a USB outlet using the charger provided in the sales box. 2. Make sure the charging plate is facing up, and that there's nothing on the plate. 3. Place your watch in the center of the charging plate. When the indicator light turns to green, the battery is fully charged.
It's normal for the charging plate and device to get warm. . Indicator lights Blue and continuous Charging Green and continuous Standby/the battery of your watch is fully charged Green and flashing Over temperature error, let the watch and charger cool down.
44'C Blue and flashing Charging error, the connected power source is not able to provide enough power If there is a problem with charging: • Check that no other object is on the plate. • If the charging plate is too warm, take your watch off the plate, and unplug the plate. The plate may switch off automatically if it is too hot. When the plate has cooled down, try charging again. • Use the charger provided in the sales box.
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
IC Warning - English: " This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. - French:" Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.