User's Manual

ManualsBrandsWenzhou Only Electronics ManualsElectronicsBluetooth Hearing Protector

Table Of Contents

User Manual

1099596 is a bluetooth earmuff,covering hearing protector device(HPD) and bluetooth device

as below picture:

BATTERY INSTALLATION

1. The 1099596 bluetooth earmuff requires 3AAA size Alkaline batteries. The battery tray is in the

left ear cup (the ear cup WITHOUT the Power / Volume Control knob).

2. Unit will not operate unless batteries are installed with correct polarity. Locate the “+” and “–”

molded into the battery tray. Place the positive end of the battery at the end of the tray nearest

to the “+”. The second battery is placed opposite to the first.

3. Without placing the ear muffs on head, check for correct battery installation by turning the

Power / Volume Control knob to verify that the LED “ON” Indicator lights when the switch is in

the “ON” position.

VOLUME KNOB

1. Identify the Power / Volume Control button

2. Turn on and adjust the volume control by button until the desired volume is achieved. It is

important to increase the volume control very gradually to avoid sudden increase in sound.When

not in use,press the button. This indicates the power to the electronics in the earmuff has been

turned off.

FITTING INSTRUCTIONS

1. For best results, it is important that the ear muff is fitted and worn properly.

2. Before ear muff is fitted to head, grasp ear cup with one hand, and headband with the other.

Slide the ear cup gently away from the headband. The wire headband frame will extend from the

guide arms about one inch.

3. Place ear muff on head, and gently collapse the headband frame into the guide arms until the

headband rests on top of the wearer’s head and the ear cups completely cover the wearer’s ears.

Summary of content (4 pages)

PAGE 1
User Manual 1099596 is a bluetooth earmuff,covering hearing protector device(HPD) and bluetooth device as below picture: BATTERY INSTALLATION 1. The 1099596 bluetooth earmuff requires 3AAA size Alkaline batteries. The battery tray is in the left ear cup (the ear cup WITHOUT the Power / Volume Control knob). 2. Unit will not operate unless batteries are installed with correct polarity. Locate the “+” and “–” molded into the battery tray.
PAGE 2
HPD OPERATING INSTRUCTIONS 1. After installation of batteries and fitting, Press the on/off button to turn on. when unit is in “On” position. A click indicates unit is “on” and visible light from the LED verifies. 2. Increase volume gradually until sounds from surroundings can be heard. 3. Amplification of surroundings is interrupted when there are bursts or impulse noises at unsafe levels. BLUETOOTH OPERATION 1. On your smart device, locate “Settings.” 2.
PAGE 3
environmental noise level should be used. Although hearing protectors can be recommended for protection against the harmful effects of impulsive noise, the Noise Reduction Rating (NRR) is based on attenuation of continuous noise and may not be an accurate indicator of the protection attainable.
PAGE 4
FCC Caution： This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.