Replacement Part List

Generator Wheel

& Handle Kit

NEED HELP? CONTACT US!

Have product questions? Need technical support?

Please feel free to contact us at:

800-232-1195

techsupport@wenproducts.com

WENPRODUCTS.COM

(M-F 8AM-5PM CST)

Model # 56410

For video instructions visit bit.ly/WHEELKIT

PAGE 1
Generator Wheel & Handle Kit Model # 56410 For video instructions visit bit.ly/WHEELKIT NEED HELP? CONTACT US! Have product questions? Need technical support? Please feel free to contact us at: 800-232-1195 (M-F 8AM-5PM CST) techsupport@wenproducts.com WENPRODUCTS.
PAGE 2
Hello and thank you for buying a WEN Generator Wheel and Handle Kit. Installation is fairly straight forward. Just follow these simple steps to get your generator up and rolling in no time. If you would prefer video instructions, feel free to visit http://bit.ly/WHEELKIT First, check to make sure your wheel kit includes all of the necessary parts. Each item comes pre-assembled with the necessary nuts and washers already attached to the proper bolts.
PAGE 3
Once both wheels are installed, attach the support legs to the generator as shown in Figure B. Again, remove the bolts, slide the legs into place and allign the two holes. Reattach the bolts using the 10/13 and the 10/12 mm wrenches. Finally, flip the generator back to its upright position and attach the two handles using the 10/13 and the 10/12 mm wrenches. Do not tighten the handles too much, as this will restrict movement and will prevent the handles from folding up and down as needed.