Assembly Guide

ManualsBrandsWEN ManualsAccessories2-Axis Digital Readout Kit for Metal Lathes (compatible with WEN, Central Machinery, and Grizzly)

Model # 3452A

Digital Readout

for Cutting Depth

Assembly Guide

bit.ly/WENvideo

NEED HELP? CONTACT US!

Have product questions? Need technical support?

Please feel free to contact us at:

800-232-1195

techsupport@wenproducts.com

WENPRODUCTS.COM

(M-F 8AM-5PM CST)

ASSEMBLY

UNPACKING

1. Cross Feed Screw

2. Compound Feed Screw

3. Cross Transition Shaft

4. Compund Transition Shaft

5. Compound Bracket

6. Cross Bracket

7. M3x25 Screw (4)

8. M4x12 Screw (2)

9. Digital Readout Box (2)

10. CR2032 Battery (2)

NOTE: The following assembly instructions were written in regards to the WEN 3455 Metal Lathe. Although this

particular kit can fit on multiple styles and sizes of metal lathes, part numbers within this manual will refer to the

exploded view for the 3455 Metal Lathe found on page 4.

NOTE: CR2032 batteries are already installed inside digital readout boxes. There is no need to remove them un-

less they need to be replaced.

Summary of content (4 pages)

PAGE 1
Model # 3452A bit.ly/WENvideo Digital Readout for Cutting Depth Assembly Guide NEED HELP? CONTACT US! Have product questions? Need technical support? Please feel free to contact us at: 800-232-1195 (M-F 8AM-5PM CST) techsupport@wenproducts.com WENPRODUCTS.COM ASSEMBLY NOTE: The following assembly instructions were written in regards to the WEN 3455 Metal Lathe.
PAGE 2
ASSEMBLY CROSS SIDE ASSEMBLY NOTE: The numbers listed below correspond to the figure numbers shown in the pictures. 1. Remove the screw (Fig. 1 - 1) and lock washer (Fig. 1 - 2) (parts 52 and 192) holding the cross slide handle (86A) onto the cross slide screw (89). 2. Remove the dial (87) and spring (190) from cross slide screw. It may take some gentle prying. 3. Remove the dial bracket (88) from the cross slide using a hex wrench. Unscrew the two screws (116). 4.
PAGE 3
ASSEMBLY 10. Assemble the handle assembly onto the slide screw. Make sure that the notch at the end of the transition shaft mates with the set screw in the cross slide screw (refer to Step 5 and its picture). Press the transition shaft up flush against the flange of the digital readout box. Tighten the set screw on the digital readout box once the transition shaft is securely in place, and turning the handle moves the cross slide forward or back, as appropriate.
PAGE 4
WEN 3455 METAL LATHE This assembly instruction guide references the WEN Variable Speed 7 by 12 Inch Two-Direction Benchtop Metal Lathe (Model 3455) exploded view and parts list. To view the manual for this item, please visit www.wenproducts.com and search for “3455”. Locate the “Download” tab and downlaod the manual for additional information.