Product Manual

INSTRUCTION MANUAL
KNOW YOUR LASER DISTANCE MEASURE
MODEL 10110
DISTANCE MEASURE
POCKET LASER
Display
ON/Measure/Units
Battery Units
Laser Beam Outlet
PREPARATION
INSTALLING BATTERIES (FIG. 1)
Your Laser Distance Measure requires two (2) AAA
standard or rechargeable batteries.
1. Twist off the end cap (Fig. 1 - 1).
2. Insert two AAA batteries into the battery
compartment (Fig. 1 - 2). Follow the diagram inside
to place the batteries in the correct orientation.
3. Replace the end cap and twist back into place.
NOTE: Always replace both batteries at the same
time. Do not use different brands or types of
batteries/rechargeable batteries together.
2
Fig. 1
1
WARNING: Read and understand all warnings, cautions and operating instructions before
using this device. Failure to follow all instructions listed below may result in personal injury
and device damage.
SAFETY RULES
WARNING: Do not direct the laser beam at persons or animals. Do not stare into the direct
or reflected laser beam, not even from a distance. Looking into the laser beam or directing the
laser beam into someone’s eyes can cause eye damage, blindness, and cause accidents.
WARNING: Do not direct the laser beam at aircraft. This is a federal crime.
WARNING: LASER RADIATION. Class 2 laser. DO NOT STARE INTO THE BEAM.
FCC STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
LASER CLASSIFICATION
The device produces visible laser beams, which are emitted from the instrument: It is a Class 2 laser
product in accordance with: IEC60825-1: 2014“Radiation safety of laser products”
INTENDED USE
The measuring tool is intended for measuring distance, lengths, heights, and clearances.
The measuring tool is suitable for indoor use.
Model 10110
Laser Type 620-690 nm, < 1 mW
Laser Class 2
Battery 2 x 1.5V (AAA)
Operating Temperature 32 to 104 °F (0 to 40 °C)
Measuring Distance 1.7 - 32 ft (0.5 - 10 m)
Measuring Accuracy ± 1/4" (± 6 mm)
Weight 36.6 g (1.3 oz)
Dimensions
5.75" x 0.87" x 0.87"
(146 x 22 x 22 mm)
Smallest Unit Displayed 1/16" (1 mm)
Reception Lens
WARRANTY
For full warranty statement, please visit WENPRODCUTS.COM and search the product number 10110.