Other Content

Wi-Fi Assist is a feature on some
iOS devices that lets you
automatically switch to mobile data
when your Wi-Fi connection is poor. This allows you to stay connected to the internet. However, with Wi-Fi
Assist enabled, your device may switch back to your saved Wi-Fi or data connections that may cause failure
when setting your Wemo®.
Before setting up your Wemo, it is recommended that you disable Wi-Fi Assist. The steps below will teach
you how.
IMPORTANT: The Wi-Fi Assist option is accessible only to devices with iOS 9 and later.
Step 1: On your iOS device, go to Settings.
Step 2: Select Mobile Data.
NOTE: This option may show as Cellular on some devices.
Step 3: Scroll down to the bottom of the page.
Step 4: When you see the Wi-Fi Assist toggle button, tap to switch it OFF.
You should now have successfully disabled Wi-Fi Assist and can now proceed with setting up your Wemo.
For instructions, click here(http://www.belkin.com/us/support-article?articleNum=8218). To restore your Wemo
to factory defaults after a failed setup, click here(http://www.belkin.com/us/support-article?articleNum=8035).
Related Articles:
Android™ smart device keeps disconnecting while setting up Wemo®(http://www.belkin.com/us/support-
article?articleNum=110936)
Common issues with Wemo® devices(http://www.belkin.com/us/support-article?articleNum=44526)
Resolving issues when setting up Wemo® using
an iOS device
Belkin Official Support - Resolving issues when setting up Wemo® usin... https://www.belkin.com/us/support-article?articleNum=293952
1 of 2 25-Oct-18, 6:52 PM