Insert wooden dowel (A) into parts (5,11,14) as per diagram.
Insert wooden dowel (A) into parts (4,6) , secure cam bolt (D) into parts (1,16) with Philips head screwdrivers per diagram.
Pick up the slider arm (X) and separate the slide Runner for the following steps. Extend the Slide .Runner all the way forward,press the plastic release lever of the slider arm up and pull the Slide Runner Complete out .
Using screw (L) attach Slider arm (X) to parts (4,6) with Philips head screwdriver as per diagram.
Using screw (L) attach Slider bracket (X) to parts (13,15) with Philips head screwdriver as per diagram.
Using bolt (E) attach part (11) to part (5) with hex key (F) as per diagram.
Using cam lock(C) secure parts (4,6) to part (11) with Philips head screwdriver as per diagram.
Put part (12) as per diagram.
Using bolt (E) attach part (19) to parts (4,6) with hex key (F) as per diagram.
Using bolt (G) attach parts (20) to part (19) with hex key (F) as per diagram.
Put parts (9,10) as per diagram.
Using cam lock (C) secure part (1) into parts (4,5,6) with Philips head screwdriver as per diagram.
Using screw (S) secure plastic wedge (R) with Philips head screwdriver as per diagram.
Using screw (L) attach handle (K) to part (16) with Philips head screwdriver as per diagram.
Using screw (M) attach parts (13,15) to part (18) with Philips head screwdriver as per diagram.
Put part (17) as per diagram.
Using screw (M) attach part (18) to part (14) with Philips head screwdriver as per diagram.
Using cam lock(B) secure part (16) to parts (13,15) ,and using cam lock (C) secure part(16) to part (14)with Philips head screwdriver as per diagram.
Place sticker (Q) cover the holes as per diagram .
Insert the assembled drawers into the unit frame, extend the Ball Bearing Slide Tracks (X) on the pedestal Side Panel all the way forward .Then align the Slide Runners on the assembled drawers with the Slide Tracks and push the drawer carefully inside until it stops. Note : if the drawer does not go in smoothly, please take it out and repeat the step.
Insert shelf support pin (N) into parts (4,5,6) as per diagram. Make sure you place the four shelf support pins (N) in the same level. So the shelf is not titled .Put parts (2,3) into unit as per diagram. Tilt and rest the adjustable shelves(2,3) onto the shelf support pins .
Using screw (L) attach handle (K) to parts (7,8) ,and using screw (J) attach Europe hinge(H) to parts(7,8) with Philips head screwdriver as per diagram.
using screw (J) attach Europe hinge(H) to part (4) with Philips head screwdriver as per diagram.
using screw (J) attach Europe hinge(H) to part (6) with Philips head screwdriver as per diagram. Open and close the doors ,if necessary adjust the screws for a good fit.
Position the assembled unit at the desired location ,if necessary adjust the floor leveler at the bottom of the legs to level the unit .
Using screw (T) attach Velcro strap (V) into part (1) with Philips head screwdriver as per diagram.
Using screw (U) attach Velcro strap (V) into Nut (W) to wall with Philips head screwdriver as per diagram.