Installation Instructions

INSTALLATION INSTRUCTIONS

Clean your countertop and position the cutout template on it as desired. Using a pencil

to draw a line on the countertop along the edge of the cutout template.

For laminated or wood countertop, drill

starter hole and cut along the line

traced around the template; for granite,

m a r b l e o r o t h e r s o l i d s u r f a c e

countertop, your fabricator will cut it

accordingly.

Remove protective film from foam

sealing strip. Apply the foam seal

approximately 1/4 inch from the edge

of the sink. Do not stretch foam strip

an d m ak e s u re t h e e n d s me e t

seamlessly.

WellsSinkware.com

I T ' S A W A T E R T H I N G

PAGE 1
WellsSinkware.com I T ' S A W A T E R T H I N G INSTALLATION INSTRUCTIONS Clean your countertop and position the cutout template on it as desired. Using a pencil to draw a line on the countertop along the edge of the cutout template. For laminated or wood countertop, drill starter hole and cut along the line traced around the template; for granite, marble or other solid surface countertop, your fabricator will cut it accordingly. Remove protective film from foam sealing strip.
PAGE 2
WellsSinkware.com I T ' S A W A T E R T H I N G Slip the mounting clips over the sink rails and into the holes on the rail (the 1-prong side of the clip should face the sink bowls). Rotate the clips according to the thickness of your countertops (see illustration). Tighten screws in mounting clips with a phillips screwdriver by hand. Warning: Use of a drill or power screw driver can strip screws! WELLS SINKWARE CORP. st 916 W.