User's Manual

ManualsBrandsWeifang Goertek Electronics ManualsElectronicsBluetooth Dongle

1. Introduce…………………………………………………………………………1

2. Specification………………………………… …………………………………..1

3. Feature………………………………………………….………………………..1

4. Method of use……………………………………………………………………1

4.1 Pairing………………………………………….…………………………..1

4.2 Auto reconnection…………………………………….……………………1

4.3 Button function............................................1

4.4 Led states.................................................1

4.5 Support skype..............................................2

1. Introduce: The VoIP dongle will enumerate as a USB device as soon as it is

plugged in. No driver was required to work with this VOIP dongle.

2. Specification:

Bluetooth Vertion： V1.2

Supported Profile: Headset, Hands-free

Data Rate(MAX) : 1Mbps

RF Output Power: Class 2

Operation Range: 10m

OS Requirements: Win 98SE/Me/2000/XP

Dimension: 63*18*9mm

Weight: 8.5g

Chip: BC3-Mutimedia External

3. Feature:

◎ to create the wireless connection between U70 and BT headset.

◎ to function as radio gateway to be powered by PC or PDA, additional power

unnecessary.

◎ to install no software in advance.

◎ to Support skype to enable pick and hang phones by only multifunction key

pressing of headset.

4. Method of use:

4.1 pairing: Upon plugging in the USB dongle if the dongle isn’t connected

or long press the mutifunction button on the board after operation

stably ，it will search new device . It may pair with the device if

someone is in the pairing ..

4.2 Auto reconnection: Upon plugging in the USB dongle or short press the

multifunction button which may both reconnect with the last paired

device. the last paired device need not be in the pairing mode. It just

need to be power on and in the idle mode.

4.3 Button function: It is divided into short press and long press.

short press the mutifunction button on the board is to reconnect to

the last-paired device.short press is define as any time <=2s.

long press the mutifunction button on the board is to trigger a new

pairing session. Long press is defined as any time >= 2 seconds.

4.4 Led states: only Blue led will blink at an interval of 0.5 second when

Summary of content (4 pages)

PAGE 1
. Introduce…………………………………………………………………………1 2. Specification………………………………… …………………………………..1 3. Feature………………………………………………….………………………..1 4. Method of use……………………………………………………………………1 4.1 Pairing………………………………………….…………………………..1 4.2 Auto reconnection…………………………………….……………………1 4.3 Button function............................................1 4.4 Led states.................................................1 4.5 Support skype..............................................2 1.
PAGE 2
the device is in the normal state. Red led will blink at an interval of 0.5 second when the signal is sent into dongle.and then blue led will blink after short press multifunction button. Blue & red leds will blink alternatively on and off when dongle is in the pairing.leds blink faster in the short press state than long press. If the dongle is connected with some device ,unplug and plug Blue& red will blink alternatively(0.1s).otherwise they will blink alternatively(0.5s). 4.
PAGE 3
Open ‘Sound Devices’ in the‘option’, set the states of the Out’ and ’Ringing’ setting. ‘ Audio In’ 、‘Audio to‘EXCELPOINT VOIP Dongle’.
PAGE 4
Federal Communications Commission (FCC) Statement 15.21 You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment. 15.105(b) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.