Brochure/Catalogue

Selection guide
PLC Cables Interfaces
Input/Output cards Standard Direct inputs/outputs Insulated inputs Insulated outputs
- see page A.35 (H,R) or A.51 (A) - - see page A.57 - - see page A.61 -
Manufacturer code Number/Type of channels Order No. Quantity Type Quantity Type Quantity Type Quantity
DI
TWD DDI 16DK 16 DI, positive logic 7789328xxx 1 H2016 1 I2016 1
TWD DDI 16DT 16 DI, positive logic 7789100xxx 1 H2016 1 I2016 1
TWD DDI 16DT
A)
16 DI, negative logic 7789100xxx 1 H2016 1
TWD DDI 32DK 32 DI 7789328xxx 2 H2016 2 I2016 2
TWD DDI 8DT 8 DI, positive logic 7789100xxx 1 H2008 1 I2016 1
TWD DDI 8DT
A)
8 DI, negative logic 7789100xxx 1 H2016 1
DO
TWD DDO 16TK 16 DO 7789329xxx 1 H2016 1 O2016 1
TWD DDO 16UK
B)
16 DO 7789328xxx 1 H2016 1 O2016N 1
TWD DDO 32TK 32 DO 7789329xxx 2 H2016 2 O2016 2
TWD DDO 32UK
B)
32 DO 7789328xxx 2 H2016 2 O2016N 2
TWD DDO 8TT 8 DO 7789100xxx 1 H2008 1 O2008 1
TWD DDO 8UT
A)
8 DO 7789100xxx 1 H2016 1
TWD DRA 16RT 16 DO 7789104xxx 1 R2416 1
TWD DRA 8RT 8 DO 7789108xxx 1 R1208 1
DI/DO
TWD LMDA 20DRT
12 DI, positive logic 7789100xxx 1 H2012 1
8 DO 7789104xxx R2416 1
TWD LMDA 20DRT
B)
12 DI, negative logic 7789100xxx 1 H2016 1
8 DO 7789104xxx R2416 1
TWD LMDA 20DTK
12 DI, positive logic
7789327xxx 1
H2012 1
8 DO H2016 1 O2016 1
TWD LMDA 20DUK
C)
12 DI, positive logic
7789326xxx 1
H2012 1
8 DO H2016 1
TWD LMDA 40DTK
24 DI, positive logic
7789327xxx 2
H2012 2
16 DO H2008 2 O2008 2
TWD LMDA 40DUK
C)
24 DI, positive logic
7789326xxx 2
H2012 2
16 DO H2016 2
AI TWD AMI 2HT 2 AI 1350480xxx 1 A1504 1
AO TWD AMO 1HT 1 AI 1350480xxx 1 A1504 1
AI/AO
TWD ALM 3LT
2 AI
1350480xxx 1 A1504
1
1 AO 1
TWD AMM 3HT
2 AI
1350480xxx 1 A1504
1
1 AO 1
Note
A) Attention! Only use interfaces without LEDs
B) Attention! Use only interfaces without LEDs for the direct option.
C) Attention! Use only interfaces without LEDs for the direct output option.
• Please, always take into account the characteristics of the PLC card (voltage, current…) when selecting interfaces.
In some cases, the card can work at higher voltages than those indicated in the interface.
• Cables 7789100xxx, 7789104xxx, 7789106xxx, 7789108xxx, 1350480xxx, 1350490xxx and 1350500xxx have wire-end ferrules at one end.
These cables do not have a PLC connector. Colour code according to DIN47100.
• The interfaces are intended to be used inside an IP20 enclosure at least.
• The last 3 digits of the cable code indicate its length in decimetres. For example, if the code ends in 100, the cable would be 10 m long.
*
In the case that an input/output card does not appear in this table, you can check our on-line PLC selection guide at
www.weidmueller.com where you will al
ways nd the most up-to-date information.
PLC SCHNEIDER – TWIDO
A
A.272690170000
Universal solutions for PLC input/ output cards