Brochure/Catalogue

Pre-assembled cables with the corresponding plug-in
connector systems are used in the connection between the
controller and the interface. These pre-assembled cables
allow maximum savings for the user, as they achieve a cost
reduction in the materials, due to fewer individual cables,
conductors and cable ducting.
PAC-UNIV Pre-assembled cables for RS F and
RS SD interfaces
This range of pre-assembled cables for ribbon cabling
complies with
IEC60603-13/DIN41651 SUB-D in
accordance with IEC60807-2/DIN41652 and SUB-D
Highdensity.
One end of the cable is prepared for connecting with the
RS-F or RS SD interfaces and the other end for wire-end
ferrules or to a SUB-D connector or ribbon cable.
Colour code acc. To DIN47,100 and available in different
lengths.
Introduction
Pre-assembled cables for general applications
PAC-ELCO Pre-assembled cables for RS ELCO
interfaces
With pre-assembled cables for ELCO connectors, one end of
the cable is prepared for connecting with the RS-ELCO
interfaces. The other end is connected to a wire-end ferrule
or to a female ELCO connector. Colour code acc. To
DIN47,100 and available in different lengths.
PAC-UNIV Pre-assembled cables with PLC original
connector
These range of pre-assembled cables are provided with the
original PLC connector in one end of the cables and with
ferrules in the other.
Colour code acc. To DIN47,100 and available in different
lengths.
Avaliable for main PLC‘s of the market. More options on
demand.
F
F.2 2690170000
Pre-assembled cables for general applications