Approval/Certificate/Document of Conformity

KEMA :I(
Translation, originallanguage: German
(1) EC-TVPE EXAMINATION CERTIFICATE
(2) Equipment and protective systems intended for use in potentially explosive
atmospheres - Directive 94/9/EC
(3)
EC-Type Examination Certificate Number: KEMA 06ATEX0177 U
Issue Number: 2
(4) Component: Terminal Blocks Types PDU 2.5/4, PDU 2.5/4/3AN , PDU 2.5/4/4AN, PDU 6/10, PDU 6/10/3AN,
PDU 16, PEI 16, Double Level Terminal Blocks PDK 2.5/4, PDK 2.5/4 N-L, PDK 2.5/4 L-PE,
PDK 2.5/4 N-PE, PDK 2.5/4 V and Protective Conductor Terminal Blocks Types PPE 2.5/4,
PPE 2.5/4/3AN, PPE 2.5/4/4AN, PPE 6/10, PPE 6/10/3AN, PPE 16 and PDK 2.5/4 PE.
(5) Manufacturer: Weidmüller Interface GmbH & Co. KG
(6)
Address:
Klingenbergstraße 16,0-32758 Detmold, Germany
(7) This component and any acceptable variation thereto is specified in the schedule to this certificate and the
documents therein referred to.
(8) KEMA Quality B.V., notified body number 0344 in accordance with Article 9 of the Council Directive 94/9/EC of
23 March 1994, certifies that this component has been found to comply with the Essential Health and Safety
Requirements relating to the design and construction of equipment and protective systems intended for use in
potentially explosive atmospheres given in Annex 1I to the directive.
The examination and test results are recorded in confidential report no. 211318500.
(9) Compliance with the Essential Health and Safety Requirements has been assured by compliance with:
EN 60079-0 : 2006 EN 60079-7 : 2007
(10) The sign "U" placed after the certificate number indicates that this certificate describes components and must not
be mistaken for a certificate intended for an equipment or protective system. This EC-Type Examination Certificate
may be used as a basis for certification of an equipment or protective system.
(11) This EC-Type Examination Certificate relates only to the design, examination and tests of the specified component
according to the Directive 94/9/EC. Further requirements of the directive apply to the manufacturing process and
supply of this component. These are not covered by this certificate.
(12) The marking ofthe component shall include the following:
This certificate is issued on July 4, 2008 and, as far as applicable, shall be revised before the date of cessation of
presumption of conformity of (one of) the standards mentioned above as communicated in the Official Journal of
the Eu Union.
112GD Ex e 11
Page 1/5
Q
PRDDucrs
RvAC DDI
rJ Integral publicatlon 01 this certilicate and adjoining reports is allowed. This Certificate may oniy be reproduced in its entirety and without any change.
KEMA Quality B.V. Utrechtseweg 310, 6812 AR Arnhem P.O. Box 5185, 6802 ED Arnhem, The Netherlands
T [phone] F [phone] [e-mail] www.kema.com Registered Arnhem 09085396
------------------------------------ Experience you can trust.