Document of Conformity

ManualsBrandsWeidmueller ManualsBrass cable glands Ex e/d - Klippon® KDSXKDSX M20 BS O NI 1 G16

SCHEDULE

EU-TYPE EXAMINATION CERTIFICATE Sira 05ATEX1286X

Issue 5

This certificate and its schedules may only be

reproduced in its entirety and without change

CSA Group Netherlands B.V.

Utrechseweg 310,

6812 AR, Arnhem Netherlands

DQD 544.09 Rev 2018-04-20 Page 2 of 5

13. DESCRIPTION OF EQUIPMENT

The KDSW, KDSX, KOSW and KOSX ranges of cable glands are intended for use with SWA/Tape/Woven

Steel Wire/Braided armoured cables. KDSW and KDSX glands comprise a threaded entry body, inner

elastomeric sealing ring, armour cone, clamp ring and compression cap; and a rear seal assembly

comprising a back nut, skid washer and outer sealing ring. The entry body is available with an optional

outer deluge seal or an integral earthing clamp. KOSW and KOSX glands are of the same construction

but without the inner elastomeric sealing ring. Sealing rings are available in silicone or neoprene.

Glands are available in the size range 16 to 100 with ISO metric entry threads of M16 to M100

respectively. Alternative thread sizes and forms ISO metric, NPT, NPSM, BSPT, BSPP, PG and ET are

available. The KDSW and KDSX glands have an ingress protection rating of IP66 and IP68 (50 metres 7

days) and the KOSW and KOSX glands have an ingress protection rating of IP66.

Variation 1 - This variation introduced the following changes:

i. To permit the batch number shown in the actual product marking to be removed.

ii. The addition of cone & clamp ring part numbers.

iii. The introduction of the KDSW, KDSX, KOSW and KOSX glands that have an IP66 rating and the

consequential modification of the special conditions for safe use.

iv. The external cylindrical diameter of the M85, M90 and M100 glands to be enlarged by 5mm to

rease the size of the marking area.

Variation 2 - This variation introduced the following changes:

i. The removal of code 2 lead conductive neoprene seals from KDSW, KDSX, KOSW and KOSX,

range of cable glands.

ii. The removal of code P lead inner seal from the KDSW, KDSX, KOSW and KOSX , range of cable

glands for lead sheathed cables and to replace it with a new code 2 neoprene seal used with a

brass continuity washer.

iii. The extension of the upper ambient service temperature limit to +85°C for cable glands

orporating neoprene seals (60° IRHD).

iv. The modification of clause 15.2 in the special conditions for safe use.

v. The removal of the temperature range markings from the seals.

vi. The introduction of drawing amendments and up dates that are in-line with current practice.

Variation 3 - This variation introduced the following changes:

i. Following appropriate re-assessment to demonstrate compliance with the requirements of the

EN 60079 series of standards, the documents originally listed in section 9, EN 50014:1997

(amendments 1 and 2), EN 50018:2000, EN 50019:2000 and EN 50281-1-1:1998, were replaced

by those currently listed, the markings in section 12 were updated accordingly.

Variation 4 - This variation introduced the following changes:

i. The UK manufacturing site was removed from the certificate.

Variation 5 - This variation introduced the following changes:

i. A clarification to the type designation of the KDSW, KDSX, KOSW and KOSX Range of Cable

Glands.