Document of Conformity

Page 9 of 28 Report No.: 2198607.50

IEC 61984

Clause Requirement + Test Result - Remark Verdict

Test acc. to: IEC 60068-2-20

Solder terminations

Other terminations, not mentioned above, acc. to

IEC standard .....................................................:

N/A

A7 CONTACT RETENTION IN INSERT: IEC 60512 Test 15a P

Test load shall be three times the specified

insertion force (mating) of one contact or the

specified insertion force of one contact plus 50 N,

whichever is less. Minimum test load 20 N.

—

VISUAL EXAMINATION: IEC 60512 Test 1a

6.18.2 Contacts safety retained P

No axial displacement likely to impair normal

operation

A8 CABLE CLAMP: IEC 60512 N/A

6.17

The cable clamp is made of insulating material or

metal.

N/A

6.17 Metal cable clamps meet one of the following requirements:

a) Provided with a covering of insulating material to

prevent any accessible metal part becoming live in

case of a fault.

N/A

b) No contact possible with the IEC test finger

according to IEC 60529.

N/A

c) Be connected to protective earth. N/A

Cable clamping range (6.17 Table 6 or

manufacturer’s specification) ............................:

from: mm

to: mm

—

A8.1 CABLE CLAMP (PULL) IEC 60512 Test 17c

VISUAL EXAMINATION: IEC 60512 Test 1a

Covers mounted / contacts not connected See appended table A8.1 N/A

A8.2 CABLE CLAMP (TORSION): IEC 60512 Test 17d

VISUAL EXAMINATION: IEC 60512 Test 1a

Covers mounted See appended table A8.2 N/A

MECHANICAL STRENGTH IMPACT (Only free Connectors and CBC): IEC 60512

Test 7b

Dropping cycles: 8 positions in 45° steps —