LUMI LEAGUE 2 PACK
GENERAL INFORMATION HOW TO BIND AND PLAY This user's manual is designed for use with your vehicles and contains the instructions you will need to assemble, operate and maintain your vehicles. (1). Turn on the vehicle first,then turn on the transmitter. (2). When the light of the transmitter is flash, that mean it's matching. (3). If the light is on and not flash, that means they are matched. (4).
(11). Play on a smooth surface for optimum performance (12). Remember to switch OFF the power of the Vehicle and Transmitter after playing (13). The optimum control range is up to 20 metres indoor BATTERY INSTALLATION Batteries not included (14). To turn on/off the light on the car, press the small round button on the side of the transmitter. Light 3x1.5V Car Radio controller (1). Please unscrew the battery cover on the car open it. (2). Insert 3 x AAA 1.
SAFETY PRECAUTIONS Do not operate during thunderstorms or rain. Avoid water, sand, grass and snow when operating the car. Do not submerge car or controller in water. Never operate your car on the street or highway Never operate your car in a confined or crowded area and do not use people or animals as obstacles.
4 MAINTAINING YOUR CAR After running your car, the following procedures should be performed regularly and will help to maintain your car's performance. Inspect your car for any obvious damage Check the gears for wear, debris or broken/slipping teeth. Check the wheels and tighten the wheel screws properly. Check for loosen screws in the chassis. Check the wiring for frayed or damaged wires or connectors. Check the steering servo which will wear out over time and require replacement. Check all batteries.
TROUBLESHOOTING PRECAUTIONS AND CARE 1. Check to see if transmitter and car are on. A. The vehicle does not work at all. 2. Replace batteries. 3. Check if there are damaged parts. 1. Replace or charge the battery pack and/or the radio batteries. B. The vehicle runs slow. 2. Make sure the vehicle is geared properly and pinion and spur gear are over tightened. 3. Clean all bushings or ball bearings. 4. Check for stripped or dirty gears. FCC STATEMENT C. The throttle works, but not the steering. D.