A WILSON ELECTRONICS, LLC COMPANY DRIVE 4G-X OTR Mobile Cellular Signal Booster Kit Truck Edition User Manual NEED HELP? support.weboost.com 866.294.
_____ Index Package Content 1 Quick Installation 2 Signal Booster Specifications 4 Frequently Asked Questions 5 Safety Guidelines 6 Light Patterns 7 Troubleshooting 7 Mobile Antenna Kit Options 8 Warranty 9
________ Package Content Installation Instructions for the Following weBoost Signal Booster: DRIVE 4G-X™ OTR 700 MHz Band 12/17 & 13 800 / 1900 (Excluding B25) AWS (1700 / 2100) Drive 4G-X Signal Booster 4G-OTR Antenna & Mount Slim Low Profile Antenna Mounting Bracket DC Power Supply THE ALUMINUM CASING OF YOUR SIGNAL BOOSTER WILL ADJUST TO THE TEMPERATURE OF ITS ENVIRONMENT, BUT IS DESIGNED TO PROTECT THE SIGNAL BOOSTER TECHNOLOGY.
________ Quick Installation 1 Remove Remove Remove 4G-OTR Antenna Mount washer with lip in the UP position 4G-OTR ANTENNA INSTALLATION Select a location on one of the mirror rails to mount the 4G-OTR Antenna that is: • At least 12 inches from any other antennas. • Free of obstructions. • At least 6 inches from any windows (including sunroofs). Remove existing nut from mount as shown. Mount antenna with fitted disc washer and nut provided in package. Add included thread lock on all threads.
Slim Low Profile Antenna 4G-OTR Antenna 4 CONNECT COAX CABLES TO DRIVE 4G-X Select a location for the Drive 4G-X that is free from excessive heat, direct sunlight and moisture and that has proper ventilation. Good locations include underneath a seat or under the dashboard. Connect the cable from the 4G-OTR Antenna to the port labeled “Outside Antenna” on the Drive 4G-X and connect the cable from the Slim Low Profile Antenna to the port labeled “Inside Antenna” on the booster.
______ Specifications Drive 4G-X OTR Product Number U470010 Model Number 460021 FCC ID: PWO460021 IC: 4726A-460021 Connectors SMA-Female Antenna Impedance 50 Ohms Frequency 699-716 MHz, 729-756 MHz, 777-786 MHz, 824-894 MHz, 1850-1995 MHz, 1710-1755 MHz/2110-2155 MHz Passband Gain (nominal) 700 MHz Band 12/17 45.8 700 MHz Band 13 46.8 800 MHz Band 5 46.8 1700/2100 MHz Band 4 45.2 1900 MHz Band 2 44.
(SPECIFICATIONS cont.) Each Signal Booster is individually tested and factory set to ensure FCC compliance. The Signal Booster cannot be adjusted without factory reprogramming or disabling the hardware. The Signal Booster will amplify, but not alter incoming and outgoing signals in order to increase coverage of authorized frequency bands only. If the Signal Booster is not in use for five minutes, it will reduce gain until a signal is detected.
Safety Guidelines Warnings Use only the power supply provided in this package. Use of a non-weBoost product may damage your equipment. The Signal Booster unit is designed for use in an indoor, temperature-controlled environment (less than 150 degrees Fahrenheit). It is not intended for use in attics or similar locations subject to temperatures in excess of that range.
Light Patterns SOLID GREEN — This indicates that your booster is functioning properly and there are no issues with installation. BLINKING RED, THEN SOLID GREEN —This indicates that one or more of the booster bands has reduced power due to a feedback loop condition called oscillation. This is a built in safety feature to prevent harmful interference with a nearby cell tower. If you are already experiencing the desired signal boost, then no further adjustments are necessary.
(TROUBLESHOOTING cont.) Light Off If the Drive 4G-X Signal Booster’s light is off, verify your power supply has power. NOTE: The Signal Booster can be reset by disconnecting and reconnecting the power supply. After troubleshooting you must initiate a new power cycle by disconnecting and then reconnecting power to the Booster. ALWAYS disconnect and reconnect power from the power supply adapter, NEVER from the Booster.
Warranty 2 YEAR WARRANTY weBoost Signal Boosters are warranted for two (2) years against defects in workmanship and/or materials. Warranty cases may be resolved by returning the product directly to the reseller with a dated proof of purchase. Signal Boosters may also be returned directly to the manufacturer at the consumer’s expense, with a dated proof of purchase and a Returned Material Authorization (RMA) number supplied by weboost. weBoost shall, at its option, either repair or replace the product.
3301 East Deseret Drive, St. George, UT www.weboost.com | support.weboost.com Copyright © 2015 weBoost. All rights reserved. weBoost products covered by U.S. patent(s) and pending application(s) For patents go to: weboost.com/us/patents NOT AFFILIATED WITH WILSON ANTENNA 111923_Rev 03_07.27.