Instructions / Assembly
Concrete Mount Installation
Concrete
Post Mount
#14 x2” SS Screw
3/8”X5”
Wedge Anchor
(with washer & nut)
Required Tools:
Hammer Drill
Masonry Bit -3/8”
Ratchet with Socket - 1/2”
Place, square and trace each concrete post
mount. Pre-drill concrete mount holes with
hammer drill at 4 1/2” depth with 3/8”
masonary bit.
Do not rush.
Place wedge anchors into each hole and tap into
concrete leaving 1” above the concrete. Place
concrete post mount over the installed
anchors and install washer and nut to each
anchor. Level and tighten with 9/16” socket.
Do not over tighten.
Line up the wood post with the concrete
post mount and pre-drill the holes of the
concrete mount into the wood with a
3/16” bit. Install the #14 x 2” screws
into the pre-drilled holes.
5
If purchasing one of our Pergolas or Arbors, please review
the concrete mount installation before installing.