RE·BL Infrared to Bluetooth Converter User’s manual User’s manual
Introduction The RE·BL is an IR to Bluetooth converter, designed to allow any universal IR remote to control a PS3 system. Using a RE·BL will allow you to fully control DVD/Blu-ray playback and power-on/off a PS3, without the need for any other remote. The RE·BL is easy to setup and only needs to be paired with a PS3 before it is ready for use.
Software In order to use the RE·BL software, the RE·BL must be connected to the PC using a USB 1.1/2.0 cable with a mini-USB connector. The RE·BL uses existing Windows drivers and does not require any additional drivers to be installed before using the software. If any changes are made to the configuration, they need to be written to the device by pressing the Save Save button. If factory Save settings need to be restored, it can be done by selecting the menu option Options > Restore default settings.
Duration Duration Specifies the time in milliseconds to activate the current command Pause Pause Specifies the time in milliseconds to pause until the next command should be sent Default Default The default button resets the currently selected macro to its default values IR device code IR device code device code tab tab By default the RE·BL responds to IR codes from the device code SONY DVD1a, but this can be changed to any SONY device code.
Product Product information Changing or removing batteries Changing or removing batteries Batteries are removed by removing the two o-rings, lift the covers apart (no screwdriver is needed) and lift the batteries from the battery-holder. Replace batteries with type 2 x “AA alkaline” (LR6). Product warranty Product warranty ct warranty The limited 2 year warranty covers production defects from the date of purchase.
Troubleshooting / FAQ 1. My RE My RE·BL RE BL BL and PS3 will not pair and PS3 will not pair Make sure all power supplies are completely removed (DC adaptor, USB and batteries inside the casing) before trying to pair the RE·BL and PS3. Also make sure that the PS3 screen says “Press ENTER+START to begin pairing”. When all power sources are removed the RE·BL should start flashing for 20 seconds when connecting either: DC adaptor, USB or batteries.
5. My remote cannot transmit the key "2" continously, so I cannot pair with the PS3. To pair with a PS3, you must go through the sequence described in: "1. [Q] My RE·BL and PS3 will not pair.". Please note: From configurations software v1.19 (firmware 1.23) and up, an autopairing feature was added which no longer requires the "2" key to be pressed. Simply enter the "Register BD Remote" menu on the PS3, and power on the RE·BL. The pairing will then initiate automatically. 6.
. When pressing the power When pressing the power--off button on my Logitech Harmony during Bluray/DVD playback, the off button on my Logitech Harmony during Bluray/DVD playback, the PS3 does not turn off? turn off? The reason is that the Logitech Harmony by default sends a stop command, then immediatly sends the power-off macro. A stop command takes a long time to execute on the PS3 (up to 10 seconds), and the power-off macro is therefore "lost".
For further information and support, visit: www.re-bl.