Installation Manual

1-1

July 2000 Part No. 920472 Rev. C

Section 1

Before You Start

1.1 Introduction

This manual explains how to install the EasyPAY™ retrofit kit in selected models of Wayne™ Vista 90

series dispensers. This includes all Models V390, V395, V490 and V590 except those with 2/ and 3/

prefix numbers.

By following this instruction manual in the sequences presented, you will be assured of a successful in-

stall. For best results, perform the steps in the sequence given for the particular kit or kits that are being

installed.

Important: These retrofit kits require installation of several wiring and hardware assemblies. Any

installation or modification must comply with the requirements of the National Electrical

Code (NFPA 70), the Automotive and Marine Service Station Code (NFPA 30A) and any

other applicable codes.

Refer to the information in Table 1-1 for identification of the EasyPAY™ retrofit kits.

PAGE 1
Section 1 Before You Start 1.1 Introduction This manual explains how to install the EasyPAY™ retrofit kit in selected models of Wayne™ Vista 90 series dispensers. This includes all Models V390, V395, V490 and V590 except those with 2/ and 3/ prefix numbers. By following this instruction manual in the sequences presented, you will be assured of a successful install. For best results, perform the steps in the sequence given for the particular kit or kits that are being installed.
PAGE 2
Section 1: Before You Start Table 1-1 EasyPAY™ Retrofit Kits for Vista Part Number 887122-001 Description EasyPAY Retrofit Kit, Vista DS Important: You must wear a static wrist strap, part number 916962 or equivalent, securely attached to an earth ground, when handling any circuit board, electronic component or assembly, or when reaching into the site controller or dispenser computer enclosure. Do not use power tools.
PAGE 3
Section 1: Before You Start 3. Make sure adequate insurance is provided when returning parts to the factory. WARNING: If the parts or components arrive at our factory in a damaged condition and it is determined that the damage is a direct result of inadequate or improper packaging, the damage will not be covered under the original warranty and the customer or distributor will be held responsible for the cost of repairs necessary to correct or replace the damaged parts. 1.
PAGE 4
Section 1: Before You Start 1-4 Part No. 920472 Rev.