Certification Exhibit FCC ID: KJ8-0003177 IC: 3540A-0003177 FCC Rule Part: 15.249 IC Radio Standards Specification: RSS-210 ACS Report Number: 09-0189-15C Manufacturer: Wayne-Dalton Corporation Model: WDHKC-50 Manual 5015 B.U.
Room Key Controller Model: WDHKC-50 Description The Room Key Controller is a battery operated Generic Z-Wave controller capable of triggering one Z-wave scene with up to 230 devices. When a generic room key card is inserted in the card slot, the Z-Wave scene triggers. The controller then goes to sleep to save batteries. When the room key card is removed all devices included into the scene will trigger to the “off” state.
To set the custom temperatures, simply power up the thermostat to be added to the network and set the modes at the desired temperatures. This must be done before adding the thermostat to the Room Key Controller. The Room Key Controller will grab the temperature set points from the thermostat when it is added to the network. Multiple thermostats are supported but only the temperatures from the first thermostat will be recorded.
Installation 1. Cut a hole in the wall at the desired mounting location with the measurements listed in figure 1 FIGURE 1 2. Use appropriate hardware to mount wall bracket aligned with the hole in the wall. Make sure the smooth side of the wall bracket is facing the wall and the rib side is facing out. Also make sure to orient the wall bracket with the faceplate nutserts facing down. See Figure 2.
Z-Wave Setup NOTE: The Room Key Controller supports the following Z-Wave functions. • • • • • Add Z-Wave Node to Scene with Level and promote to primary (when adding controllers). Remove Node from Scene and Network. Factory Reset. Join existing network with scenes. Inclusion Controller. NOTE: Features not supported by Room Key Controller. • • Replicate Network out. Scene Command Class. Add Z-Wave Node to Network and Scene 1. Press “COPY” button. LED will flash. Release. 2.
Remove Node from Network and Scene 1. Press the “REMOVE” button. LED will flash. Release. 2. Press the operate button on the Z-Wave node you want to delete from the network. Release. 3. LED will turn off indicating success. Factory Reset 1. 2. 3. 4. Press and hold the “COPY” and “RESET” buttons. Hold the buttons until the LED Turns on (about 5 seconds). Release buttons. The LED will flash 10 indicating success. NOTE: This is a destructive function.
which can be determined by turning the equipment off and on, the user in encouraged to try and correct the interference by one or more of the following measures: a) reorient or relocate the receiving antenna, b) increase the separation between the equipment and receiver, c) connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.