Certification Test Report 908.42 MHz Low Power Communication Device Transceiver 372 MHz Discrete Receiver FCC ID: KJ8-0001715 IC: 3540A-0001715 FCC Rule Part: 15.249 IC Radio Standards Specification: RSS-210 ACS Report Number: 07-0186 - 15C Manufacturer: Wayne-Dalton Corporation Model: 3790-Z Installation Guide Section1 5015 B.U.
INSTALLATION INSTRUCTIONS AND OWNER’S MANUAL FPO for TORQUEMASTER®/ TORQUEMASTER® PLUS Models: 3790/3790-Z/3791/3791-Z Installation Instructions and Owner’s Manual FPO USE OF THIS MANUAL WHEN INSTALLING A NEW DOOR WITH AN IDRIVE®: If you just finished installing a new garage door along with an idrive® opener, then proceed with these instructions beginning with Step 15 on page 22.
Package Contents Controls Learn S1 S2 S3 S4 Delete Opener Mounting Bracket Key chain/Visor Transmitter (2) To Operate D Pr e He ss re r oo Disconnect Cable 12 34 56 78 Deluxe Multi-function Wireless Wall Station 90 Entrapment Label 5 Button Wireless Keyless Entry Disconnect Handle Disconnect Handle Bracket FPO “S” Hook Lock Arm Assembly Security Light with Diffuser Cable Clips (4) Emergency Disconnect Label Jumper (Optional for Safety Sensors) 1/4” x 2" Hex Head Lag Screws (2) 1/4”
PRE-INSTALLATION INSPECTION OF YOUR GARAGE DOOR PRIOR TO TORQUEMASTER® IDRIVE® INSTALLATION Congratulations, you have just purchased one of the world’s safest garage door openers! By design, this opener will detect obstructions and reverse rather than force the door through obstructions. To ensure your new idrive® opener works as intended, your garage door must be installed and balanced properly.
PRE-INSTALLATION INSPECTION CAUTION! Do not install this opener on your door unless the following requirements are met. Electrical outlet on the ceiling is for light/opener Electrical outlet on the wall is for opener A Mounting Surface C Torquemaster® Plus Torquemaster® B 1” Clearance for Motor Controls Torque Tube Learn S1 S2 S3 S4 Delete End Bracket Top of Door Pre-Installation Inspection CAUTION: DO NOT INSTALL THIS OPENER ON YOUR DOOR UNLESS THE FOLLOWING REQUIREMENTS ARE MET.
System Requirements CAUTION TO REDUCE THE RISK OF INJURY, USE THIS OPENER ONLY WITH THE FOLLOWING DOOR MODELS: WAYNE-DALTON DOOR MODEL WAYNE-DALTON SPRING SYSTEM TRACK (RADIUS) PHOTOELECTRIC SAFETY SENSORS LOW HEAD ROOM KIT 9000 SERIES Torquemaster® Torquemaster® Plus 10",12",14",15" Not Required Not Required 9000 SERIES Torquemaster® Torquemaster® Plus 6" Low Head Room Not Required P/N 302883 Required 8000 SERIES Torquemaster® Torquemaster® Plus 10",12",14",15" P/N’s 252118 or 301674 Requ
Table of Contents Package Contents ............................................................................... I. Pre-Installation Inspection ................................................................... II, III Tools Needed ...................................................................................... IV. Important Safety Instructions .............................................................. V. Retro-Fit Installations ..................................................................
INSTALLATION NOTICE: If installing the idrive® opener on a door currently installed with Torquemaster® or Torquemaster® Plus counterbalance system, start the installation with Step: R1 below (for Torquemaster® Plus) or Step: R1 on page 3 (for Torquemaster®). Retro-Fit TorqueMaster® Plus Retro-Fit Installation Drum Wrap & End Bracket Removal R1 Tools Needed: Step Ladder Drum Wrap IMPORTANT! RIGHT AND LEFT HAND IS ALWAYS DETERMINED FROM INSIDE THE BUILDING LOOKING OUT.